Overview
The 68004070AB is a Dana30/44 drive shaft yoke flange for Dana 30 JK and Dana 44 JK front axles. It is a direct fit for the 2007–2018 Jeep Wrangler (JK).
The flange is the drive-side piece that the driveshaft yoke bolts to on the pinion. Crown Automotive makes replacement parts for Jeep vehicles. Before installing, compare the diameter, bolt pattern and bolt count against the flange you remove.
Key features
- Dana30/44 drive shaft yoke flange
- Front axle position
- Dana 30 JK and Dana 44 JK axle types
- Direct fit
Pinion yoke care
The yoke flange sits between the pinion and the driveshaft, so its fit and bolt tightness affect driveline smoothness. A loose flange can cause vibration at speed, and a damaged one can wear the pinion seal and bearings over time.
Before replacing a flange, check the pinion nut torque, the seal condition and any play at the yoke. Replacing the flange is often paired with a new pinion seal, since the seal rides against the flange surface.
Mark the driveshaft and flange before removal so the bolts return to their original positions. Use the vehicle’s torque specification and a new nut where the service procedure calls for one. Check the driveline for vibration after a short test drive, and recheck bolt torque after the first few runs.
- Vibration at highway speed
- Oil seepage at the pinion seal
- Play felt at the yoke
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 68004070AB |
| UPC | 70000637610 |
| Position | Front |
| Axle types | Dana 30 JK and Dana 44 JK |
| Component | Drive shaft yoke flange |
| Fitment | Direct fit |
Vehicle fitment
It fits 2007–2018 Jeep Wrangler (JK) models.
The list does not include the TJ, LJ or JL Wranglers. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One drive shaft yoke flange.








