Overview
The Dana 44 rear driver side axle shaft, part 5086633AA, is a 30 spline shaft for the rear left position on TJ Rubicon axles. It works with disc or drum brakes.
It is a direct fit replacement for the rear driver side. Match its 30 spline count to your differential before installing it.
Key features
- Rear driver side shaft
- 30 splines
- Works with disc or drum brakes
- Direct fit replacement for the rear driver side
- Fits 2003–2006 Jeep Wrangler (TJ)
Axle shaft inspection and installation
An axle shaft transfers power from the differential to the wheel, so any wear in the splines or the shaft body affects drive and steering feel. Check the splines for rounding, and look for cracks near the shaft ends, especially after hard use off road. A shaft that clicks on turns or vibrates at speed may need replacement.
Clean the spline surfaces and the axle flange before installing, and use the retaining hardware the job calls for. Because this shaft is for a Dana 44 rear, check that the differential side and axle flange match the shaft before starting. Replacing the axle seal and inspecting the wheel bearing at the same time saves a repeat job.
- Check the spline surfaces for rounding
- Inspect the shaft ends for cracks
- Replace the axle seal when the shaft is removed
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 5086633AA |
| UPC | 848399035025 |
| Axle type | Dana 44 |
| Axle location | Rear |
| Side | Driver side |
| Position | Rear left |
| Spline count | 30 splines |
| Brakes | Disc or drum |
| Fit | Direct fit |
Vehicle fitment
It fits 2003–2006 Jeep Wrangler (TJ) models, including the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
Wrangler TJ models from before 2003 and LJ models are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Match the 30 spline count to your differential before you install the shaft.
What’s included
One rear driver side axle shaft.







