Overview
This G2 Dana 44 rear passenger side shaft, part 95-2033-002, has 30 splines and is built for the rear right position. It is forged from 1541H steel and induction heat treated for added torsional strength.
It is built to replace stock axle shafts and to handle high-torque loads. Forging and heat treatment are intended to correct common faults found in factory shafts.
Key features
- Rear passenger side shaft with 30 splines
- Forged from 1541H steel
- Induction heat treated for added torsional strength
- Direct fit
- Designed to replace stock axle shafts
Dana 44 passenger side fitment
A rear passenger side shaft on a Dana 44 carries torque from the carrier to the right rear wheel, so it is one of the more heavily used parts on a Jeep axle. In XJ, LJ and TJ models, wear often shows as a clicking sound on turns or a vibration under power. Replacing the shaft is a good time to inspect the carrier bearing and seals as well.
Forged and induction heat treated shafts are chosen for their torsional strength, which is useful on trails and when running larger tires. Check the spline count, the axle end type and the U-joint size before installing. Bearings and seals are not part of this shaft, so plan to buy them if they are worn.
- Confirm the passenger side before ordering
- Measure the shaft length against the old one
- Inspect U-joints and retainers during the swap
- Replace the axle seal when the axle is open
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2033-002 |
| UPC | 631410123357 |
| Axle type | Dana 44 |
| Axle location | Rear |
| Position | Rear right |
| Side | Passenger side |
| Spline count | 30 splines |
| Material | Forged 1541H steel |
| Heat treatment | Induction heat treated |
| Fit | Direct fit |
Vehicle fitment
It fits 1987–1990 Jeep Cherokee XJ, 2004–2006 Jeep Wrangler LJ and 1997–2006 Jeep Wrangler TJ across the trims covered.
Other Cherokee and Wrangler years and generations, including the JK, are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the 30 spline count and the passenger side rear position against your axle before you start the job.
What’s included
One rear shaft for the passenger side of a Dana 44.
Not included: U-joint, bearings and seals.







