Overview
The Crown Automotive 8127070K is an AMC Model 20 rear driver side axle shaft kit, 26.25 inches long with 29 splines, for the 1976–1983 Jeep CJ5, the 1976–1981 CJ7 and the 1981 Scrambler. Crown Automotive sells the 8127070K as a Model 20 axle shaft kit for the driver side of the rear axle, in the Narrow-Trac CJ application. The AMC Model 20 is the rear axle that Crown Automotive names for these classic Jeeps.
The kit is 26.25 inches long with 29 splines and is a Model 20 axle shaft kit. Check the kit parts against your installation before starting. The 26.25 inch length marks it as the driver side kit, and the passenger side kit is longer. The Narrow-Trac designation means the narrower rear axle width used in CJ models, so a Jeep with a wide-track axle needs different parts. CJ5 and CJ7 owners and 1981 Scrambler owners fit within the years below. Replacing both rear shafts requires this driver side kit and the matching passenger side kit, 8127071K.
Key features
- Driver side rear axle shaft kit
- AMC Model 20 axle
- 26.25 inches long
- 29 splines
- Narrow-Trac CJ application
- Classed by Crown Automotive as a direct fit
Rear axle shaft wear
An axle shaft transmits power from the differential to the wheel hub, so its failure usually shows up as a loss of drive or a wheel that wobbles. Worn bearings, cracked splines, and damaged seals are the typical problems on older axles. Oil leaking from the axle end onto the brake drum is a sign that the seal or bearing needs attention.
When installing a shaft, clean the axle flange and inspect the hub bore for wear. Check the bearing retention method used by the axle before removing the shaft, since the approach differs between designs. Keep the brakes in mind, because a drum or shoe that has been removed may need adjustment before the wheel turns freely again.
- Oil at the axle end or drum
- Wheel wobble or noise under load
- Cracked or worn splines
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 8127070K |
| UPC | 848399078053 |
| Axle manufacturer | AMC |
| Shaft location | Driver Side |
| Axle position | Rear |
| Axle type | AMC 20 |
| Position | Rear |
| Spline count | 29 Splines |
| Length | 26.25 inches |
| Kit | Model 20 axle shaft kit |
Vehicle fitment
The 8127070K fits CJ-era Jeeps.
- 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade)
- 1976–1981 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Renegade)
- 1981 Jeep Scrambler (Base)
The CJ5 is covered 1976–1983, the CJ7 only 1976–1981 and the Scrambler only 1981. Later CJ7s and the YJ are not in the list. Confirm your vehicle’s year, model and trim before ordering.








