Overview
The Crown Automotive Dana 44 JK rear axle shaft, part 68003272AA, is a 30 spline rear shaft for the driver or passenger side. It fits 2007–2018 Jeep Wrangler JK 2-door and 4-door models equipped with a standard differential, a Trac Loc or an anti-spin differential.
It is a direct fit replacement. It covers the full 2007–2018 JK range across the covered trims, so confirm the differential type in your rear axle before ordering.
Key features
- Rear shaft for driver or passenger side
- 30 splines
- For 2-door and 4-door Wrangler JK models
- Works with standard, Trac Loc and anti-spin differentials
- Direct fit replacement for the covered Wrangler JK trims.
Rear axle shaft basics
A rear axle shaft transfers power from the differential to the wheel, so it carries torque on every acceleration and on the trail. Wear usually shows up as a clunk, vibration or a leak at the axle seal. Problems at one end often affect the other, which is why inspecting both ends during a repair pays off.
Because this shaft works with standard, Trac Loc and anti-spin units, the differential type should be confirmed before you buy. Installing a shaft for the wrong differential can leave the wheel and carrier mismatched. Clean the spline and bore, check the seal surfaces, and use fresh gasket material when the carrier cover is removed.
- Check the spline ends for twisting or wear
- Inspect the axle bearing for play or noise
- Replace the seal when leaking fluid is found
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 68003272AA |
| UPC | 848399047752 |
| Axle type | Dana 44 JK |
| Axle location | Rear |
| Side | Driver or passenger |
| Spline count | 30 splines |
| Body style | 2-door and 4-door |
| Compatible differentials | Standard, Trac Loc and anti-spin |
| Fit | Direct fit |
Vehicle fitment
It fits 2007–2018 Jeep Wrangler (JK) models across the covered trims.
Wrangler TJ, YJ and LJ models are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Match the differential type to your rear axle before installing. The shaft works with standard, Trac Loc and anti-spin units.
What’s included
One rear axle shaft, driver or passenger side.






