Overview
The Crown Automotive J81270711 is an unpainted metal rear right axle shaft kit for the 1976–1983 Jeep CJ5, the 1976–1981 CJ7 and the 1981 Jeep Scrambler. It is a direct fit for those vehicles.
The kit is rear right, unpainted and metal, and it fits as direct fit and universal fit. Confirm the axle type, spline count and length against your axle before installing.
Key features
- Axle shaft kit
- Rear right position
- Unpainted metal
- Direct fit for the listed CJ5, CJ7 and Scrambler trims
- Crown Automotive replacement part
Axle shaft fit and care
An axle shaft carries drive torque from the differential to the wheel, so fit and condition matter as much as the part number. Inspect the axle flange, bearing and seal before installing a new shaft, and make sure the flange surface is clean. Splines that show wear or twist should be replaced.
Check the axle shaft’s spline count, length and flange pattern against your axle before fitting. A shaft that is slightly short can pull out under load, which is a safety risk. Confirm the wheel bearing is in good condition and that the brake backing plate is secure after reassembly.
- Clean the flange before fitting
- Check the bearing for play
- Inspect the seal for leaks after the first drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J81270711 |
| UPC | 848399069020 |
| Product type | Axle shaft kit (replacement axle shaft) |
| Position | Rear right |
| Finish | Unpainted |
| Material | Metal |
| Fitment type | Direct fit and universal fit. |
Vehicle fitment
The kit fits the 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade), the 1976–1981 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Renegade) and the 1981 Jeep Scrambler (Base).
The CJ7 is covered only through 1981, so 1982–1986 CJ7 models are not covered, and the YJ Wrangler and other Jeep models are not covered. This is the rear right shaft only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Support the vehicle on jack stands or a lift on level ground, never on a jack alone. Tighten all fasteners to the torque values in the service manual for your vehicle, then re-check fastener tightness after the first miles of driving.
Steering and axle components are safety-critical, so professional installation is recommended. Have the steering and front end inspected and a wheel alignment performed afterward.
Axle shafts are driveline components, so check the axle, bearings and seals during the work, and use the correct axle fluid for your axle.
What’s included
One axle shaft kit for the rear right position.
Not included: A left shaft, bearings, seals and axle fluid.









