Overview
The Crown Automotive 53000403 is a flanged Dana 35 rear driver side axle shaft, 30.35 inches long with 27 splines. It fits the 1984–1989 Jeep Cherokee XJ, the 1986–1989 Comanche and the 1987–1989 Wrangler YJ, in the rear left position.
Coverage runs only through the 1989 model year, so owners of later XJ, Comanche or YJ models need a different shaft number. On a Dana 35 the driver side shaft is the longer of the two, so length and side must match. Check the spline count and flange style against your old shaft before ordering, since a non-flanged shaft will not bolt up the same way.
Key features
- Driver side rear axle shaft
- Flanged style, 30.35 inches long
- Dana 35 rear axle, 27 splines
- Position given as rear left
- Classed by Crown Automotive as a direct fit
Matching a replacement axle shaft
An axle shaft transfers torque from the differential to the wheel hub, so it has to match the axle housing, the spline count and the flange pattern at the hub. On a Dana 35 rear axle, the shaft also runs through the bearing and seal at the housing end, so the seal surface and bearing condition matter as much as the shaft itself. A shaft that twists, has rounded splines or shows heat marks near the flange should be replaced before it fails on the trail.
Before buying a replacement, measure the old shaft and compare the length, the spline count and the flange style with the new one. Look at the axle housing for oil leaks and check the wheel bearing for play, since a worn bearing can damage a new shaft quickly. Replacing the seal at the same time is a sensible step, and clean the splines before fitting.
- Measure overall length before ordering
- Inspect the axle housing seal for leaks
- Check the wheel bearing for play before fitting
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 53000403 |
| UPC | 848399016611 |
| Axle manufacturer | Dana |
| Shaft location | Driver Or Passenger |
| Axle position | Rear |
| Axle type | Dana 35 |
| Position | Rear Left |
| Spline count | 27 Splines |
| Length | 30.35 inches |
| Style | Flanged |
Vehicle fitment
Crown Automotive lists three vehicles for the 53000403, all ending in 1989.
- 1984–1989 Jeep Cherokee (XJ) (Base, Chief, Laredo, Limited, Pioneer, Sport)
- 1986–1989 Jeep Comanche (Base, Chief, Custom, Eliminator, Laredo, Pioneer, X, XLS)
- 1987–1989 Jeep Wrangler (YJ) (Base, Islander, Laredo, S, Sahara, Sport)
The XJ, Comanche and YJ are covered only through 1989, and the TJ is not covered. Later years of these models need a different shaft. Confirm your vehicle’s year, model and trim before ordering.








