Overview
The Crown Automotive 83502882 is a Dana 35 rear passenger side axle shaft, 28.85 inches long with 27 splines, for non-ABS 1984–1989 Jeep Cherokee XJ, 1986–1989 Comanche and 1987–1989 Wrangler YJ models. Crown Automotive limits the 83502882 to non-ABS models, so it suits the earlier vehicles in the list that had no ABS rear axle. It is the passenger side shaft of the Dana 35 rear axle, in the rear right position.
At 28.85 inches it is shorter than its driver side counterpart. It is a direct fit for non-ABS vehicles, and all the fitted vehicles end at the 1989 model year. The driver side shaft is the separate 83502883. The shaft has 27 splines, which is useful to compare with your old shaft. Replacing both rear shafts means fitting this passenger side shaft together with its driver side partner, 83502883.
Key features
- Passenger side rear axle shaft
- 28.85 inches long
- Dana 35 rear axle, 27 splines
- For non-ABS models only
- Position given as rear right
- Classed by Crown Automotive as a direct fit
Rear axle shaft replacement
A rear axle shaft carries torque from the differential to the wheel, so its condition affects drivetrain strength and wheel bearing life. Worn splines, twisting or cracks usually show up as a clunk when accelerating or braking, or as vibration under load. Inspect the shaft whenever the axle is opened.
The inner seal and the outer bearing are usually handled in the same job. Clean the spline area and the bore, and replace the axle seal when the shaft is out. Check that the ABS setup matches the vehicle before buying, since a shaft for a non-ABS axle is not interchangeable with one for an ABS axle.
- Inspect the splines for twisting or wear
- Replace the axle seal when the shaft is removed
- Check the bearing and retainer condition
- Verify the ABS setup before ordering
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 83502882 |
| UPC | 848399075229 |
| Axle manufacturer | Dana |
| Shaft location | Passenger Side |
| Axle position | Rear |
| Axle type | Dana 35 |
| Position | Rear Right |
| Spline count | 27 Splines |
| Length | 28.85 inches |
| ABS | Non-ABS models |
Vehicle fitment
It fits three older Jeep models.
- 1984–1989 Jeep Cherokee (XJ) (Base, Chief, Laredo, Limited, Pioneer, Sport)
- 1986–1989 Jeep Comanche (Base, Chief, Custom, Eliminator, Laredo, Pioneer, X, XLS)
- 1987–1989 Jeep Wrangler (YJ) (Base, Islander, Laredo, S, Sahara, Sport)
Coverage ends at 1989 for the XJ, Comanche and YJ, and applies to non-ABS vehicles only. TJs and later models are outside the list. Confirm your vehicle’s year, model and trim before ordering.








