Overview
The Rubicon Express RE3801 is a complete adjustable control arm kit for the 1997–2006 Jeep Wrangler TJ and the 1993–1998 Jeep Grand Cherokee ZJ. The kit has eight arms covering the front lower, front upper, rear lower and rear upper positions.
The arms are built from thick wall DOM tubing. The kit is an OE replacement for damaged factory control arms and adds adjustment to a short arm suspension. It can bolt directly to any short arm kit for additional flex.
The upper arms adjust from factory length to 1 inch longer, which helps tune pinion angle, caster and wheelbase. The adjustable super-flex upper and lower arms use PTMEG bushings, greasable zerk fittings and a power coat finish.
Key features
- Eight arms: front lower, front upper, rear lower and rear upper
- Adjustable super-flex upper and lower arms
- Upper arms adjust from factory length to 1 inch longer
- PTMEG bushings
- Greasable zerk fittings
- Power coat finish
Setting up adjustable arms
Adjustable control arms change how the axle sits under the vehicle, which affects pinion angle, caster and wheelbase. Changing one of these settings moves the others, so it helps to make small adjustments and measure after each change. A driveline vibration at highway speed often points to pinion angle, while a pull or wander on the road often points to caster or toe.
Before adjusting, check the existing bushings and joints for wear, and grease the zerk fittings so the arms move freely. Upper arms that are worn or bent should be replaced as a matched set rather than one at a time, so both sides stay the same. Once the geometry is set, a professional alignment confirms the toe and camber and keeps tire wear even.
- Make small adjustments and measure after each one
- Inspect bushings and joints before adjusting
- Replace worn arms in matched sets
- Re-check adjustment bolts after the first few drives
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE3801 |
| Arms included | 8 |
| Arm positions | Front lower, front upper, rear lower, rear upper |
| Construction | Thick wall DOM tubing |
| Upper arm adjustment | Factory length to 1 inch longer |
| Bushings | PTMEG |
| Lubrication | Greasable zerk fittings |
| Finish | Power coat |
Vehicle fitment
It fits 1997 to 2006 Jeep Wrangler TJ and 1993 to 1998 Jeep Grand Cherokee ZJ models.
The year ranges do not include the 1999–2004 Grand Cherokee (WJ). Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Set the adjustable upper arms for pinion angle, caster and wheelbase, then have the alignment checked. The kit is a direct bolt-on to any short arm kit, so it can be added to an existing short arm setup.
What’s included
Eight control arms covering the front lower, front upper, rear lower and rear upper positions, with PTMEG bushings and greasable zerk fittings.













