Overview
The Bilstein 33-238555 is a 5100 Series rear shock absorber for the 2013–2018 Ram 3500, based on the manufacturer fitment list. It is a mono tube, non-coilover shock with a 46mm smooth body, a 14mm shaft and a zinc plated finish, and it is rated for stock height up to a 1 in. lift.
A mono tube damper uses a single pressure tube with one piston, which is the internal design Bilstein gives for this shock. Bilstein says its dampers are meant to improve ride control and comfort on trucks, vans and SUVs. This unit has no reservoir and includes a boot. Its collapsed length of 18.33 in, extended length of 29.88 in and travel of 11.55 in are set out in the specifications below, so you can compare them with the shock you are replacing.
Key features
- Mono tube internal design
- 46mm ID smooth body, non-coilover
- Rear position, direct fit
- Rated for stock height up to a 1 in. lift
- Boot included, no reservoir
Matching shock length and lift
Before fitting a replacement, compare its collapsed and extended lengths with the shock you are removing. Those two measurements set how far the shock can extend and compress, so a mismatch can limit suspension travel or put the shock under strain. Measuring the old unit with the truck supported gives you a clear reference.
This is a mono tube design, which means it uses a single pressure tube and one piston. Without a separate reservoir, the unit is simpler in layout, but the body and the boot should be kept clean. Dirt on the piston rod can wear seals over time, so inspect the boot for tears whenever the suspension is serviced.
Because the rating is for stock height up to a modest lift, a taller lift may need a different shock. Check the suspension height before installation and recheck the alignment after any change in ride height.
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 33-238555 |
| UPC | 651860741741 |
| Shock series | 5100 Series |
| Position | Rear |
| Fitment type | Direct fit |
| Lift height | w/0 – 1 in. lift |
| Collapsed length | 18.33 in |
| Extended length | 29.88 in |
| Travel length | 11.55 in |
| Shaft diameter | 14mm |
| Body design | 46mm ID smooth body (non-coilover) |
| Internal design | Mono tube |
| Reservoir | No |
| Finish | Zinc plated |
| Boot | Included |
Vehicle fitment
The shock fits 2013–2018 Ram 3500 in these trims: Big Horn, Laramie, Laramie Limited, Laramie Longhorn, Limited, Lone Star, SLT, ST and Tradesman. It is a direct fit replacement for those trucks.
Other Ram models are not covered, and it is rated for stock height up to a 1 in. lift. Check fit against your vehicle’s year, model and trim before buying.
Installation notes
Bilstein rates this shock for stock height up to a 1 in. lift, so check your truck’s suspension height before fitting it. Compare the collapsed and extended lengths with the shock being removed, since no other mounting dimensions are listed. Support the truck securely on stands before removing any rear shock.
What’s included
One Bilstein 5100 Series rear shock absorber with its boot.









