Overview
The Bilstein 5100 Series 33-187280 is a rear shock absorber for the 2008–2022 Toyota Sequoia. It is designed for lifted trucks and prerunners and has a rear lifted height of 0 to 1 inch. A boot is included with the shock.
The shock uses a single-tube, high gas pressure design. Its monotube body keeps the damping oil separate from the gas charge. It has a high-flow piston intended to reduce harshness, along with independent rebound and compression tuning, and it is designed for consistent damping over long use.
The unit has eyelet mounts at both ends, a 14mm shaft and a zinc-plated smooth body. Its collapsed length is 13.71 inches, its extended length is 19.29 inches and its travel is 5.58 inches. It is designed for lift kits that keep the stock mounting configuration.
Key features
- Monotube gas pressure construction
- Self-adjusting deflecting disc valving
- High-flow piston that reduces harshness
- Independent rebound and compression tuning
- Larger working piston area for damping control, and control for large-diameter tires
- Designed to use the stock OEM mounting configuration
Boot care and mounting
The eyelet mounts on a shock like this take the load through bushings at each end, so the bushings and bolts should be checked whenever the shock is removed. Eyelet mounts give a simple pivot, but worn or cracked bushings let the shock move side to side and can make steering feel vague on a lifted Sequoia.
A boot protects the shaft from dirt, sand and road debris. Inspect it at tire rotations or oil changes for cracks, tears or grit inside, and keep the shaft clean when washing the underbody. Replacing a damaged boot early helps protect the seal, and a shock with a torn boot or a leaking body should be replaced rather than patched on the trail.
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 33-187280 |
| Shock series | 5100 Series |
| Position | Rear |
| Rear lifted height | 0 to 1 in |
| Collapsed length | 13.71 in |
| Extended length | 19.29 in |
| Travel | 5.58 in |
| Lower mount | Eye, 19.1mm |
| Upper mount | Eye, 19.1mm |
| Shaft diameter | 14mm |
| Body | 46mm smooth, non-coilover |
| Reservoir | No |
| Boot | Included |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2008 through 2022 Toyota Sequoia.
Toyota Sequoia models from before 2008 and other Toyota trucks and SUVs are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear shock absorber with its boot.
Installation notes
It is designed for lift kits that use the stock mounting points, so check the mounting before fitting. Confirm the rear lift stays within the 0 to 1 inch range the shock is built for.









