Overview
It is a rear shock absorber for the 2018 through 2026 Jeep Wrangler (JL), covering two-door and four-door models. It is built for a rear lifted height of 3 to 4.5 inches and is sold individually.
The shock has a 46mm zinc-plated smooth body with a non-coilover design. Its collapsed length is 19.49 inches and its extended length is 31.68 inches, so the lift height is the key figure to check against your truck. The unit is a monotube design with a digressive piston, which Bilstein describes as tuned for each specific application.
It needs bump stop extensions suited to the lift, and these are not included, so source them before installing the shock.
Key features
- Rear lifted height of 3 to 4.5 in
- Requires bump stop extensions
- Collapsed length 19.49 in and extended length 31.68 in
- Smooth 46mm zinc-plated non-coilover body
- Monotube design with a digressive piston
Bump stops and lift height
Bump stops limit how far the axle can compress before the suspension stops, and they protect the shock from bottoming out. When a Wrangler JL is lifted, the travel the stock stops allow changes, so extensions are often needed to restore the correct stopping point. Extensions should be sized for the lift you run, and they should be checked for fit against the axle and frame before the truck is driven.
Along with the shock and extensions, look at brake lines, sway bar links and driveshaft angles, since a larger rear lift changes their geometry. Inspect the old bump stops for cracks, flattening or missing rubber, and replace worn ones at the same time. Recheck the rear ride height and listen for clunks after the first few drives.
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 33-292977 |
| Shock series | 5100 Series |
| Position | Rear |
| Rear lifted height | 3 to 4.5 in |
| Body diameter | 46mm |
| Collapsed length | 19.49 in |
| Extended length | 31.68 in |
| Bump stop extensions | Required, not included |
| Shock type | Monotube |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2018 through 2026 Jeep Wrangler (JL), covering the two-door and four-door body styles and the Unlimited models in that range.
Wranglers from before 2018, including the JK, and the JT Gladiator are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear shock absorber.
Not included: Bump stop extensions, which are required for this lift.
Installation notes
Bump stop extensions are needed for this lift, so source them before the install. Check the rear ride height once the new unit is in place.










