Overview
The Bilstein 24-002561 is a 46mm monotube gas-charged shock absorber from the Bilstein 4600 Series, made for the 1966-1967 Jeep Gladiator and the 1981-1987 Toyota Land Cruiser. It has a yellow finish, a 2 inch body diameter and a shock boot.
The monotube design moves heat from the oil to the outer surface of the shock body, where it dissipates efficiently. A dividing piston lets the oil expand as it warms, which helps prevent aeration and foaming and keeps damping steady as temperatures rise. Part number BIL24-002561 is a direct-fit replacement for the vehicles above.
Confirm whether your vehicle needs the front or rear position before ordering.
Key features
- Monotube, gas-charged design in the 46mm class
- Part of the Bilstein 4600 Series
- Yellow finish
- 2 inch body diameter
- Shock boot included
- Direct-fit application for the listed vehicles
- The piston head allows compression and rebound damping to be tuned independently.
Monotube shocks explained
A monotube shock uses a single tube with a piston separating gas and oil, which keeps the damping fluid under steady pressure. That layout suits trucks and off-road use, where heat builds quickly on long descents and repeated bumps.
Shock service life depends on how the vehicle is driven and maintained. Inspect the shock body for leaks, check the mounting eyes for wear, and look at the boot for cracks that let dirt reach the shaft. Replacing shocks in pairs on the same axle keeps the ride even from side to side.
Bushings and mounts should be checked whenever a shock is replaced, since worn hardware can make a new shock feel loose.
- Look for oil leaks along the body
- Check boots for cracks
- Replace shocks in pairs on one axle
Specifications
| Brand | Bilstein |
|---|---|
| Part number | BIL24-002561 |
| Product type | Monotube shock absorber |
| Shock series | 4600 Series |
| Piston and tube | 46mm monotube |
| Body diameter | 2 inch |
| Finish | Yellow |
| Shock type | Monotube, gas charged |
| Position | Front or rear position: confirm for your vehicle before ordering. |
| Fitment type | Direct fit |
| Boot | Shock boot included |
Vehicle fitment
The stored manufacturer fitment list for Bilstein 24-002561 covers the 1966-1967 Jeep Gladiator (Base) and the 1981-1987 Toyota Land Cruiser (Base).
Fitment covers the 1966-1967 Jeep Gladiator (Base) and 1981-1987 Toyota Land Cruiser (Base). Other model years fall outside this fit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Suspension, steering and axle components are safety-critical, so professional installation is recommended. Torque every fastener to the correct value for your vehicle before driving.
- Support the vehicle on rated jack stands on level ground; never work under a vehicle held only by a jack.
- Inspect nearby bushings, mounts and hardware while the area is open, and replace anything worn.
- Re-check fastener torque after the first miles of driving, and again at regular service intervals.
- Have the alignment checked after any suspension or steering work.
- Confirm tire, brake line and wiring clearance through the full range of suspension travel before driving normally.
What’s included
A shock boot is included with the shock.
Not included: Mounting hardware and bushings are not included; check what your vehicle needs before starting.









