Overview
The Dana Spicer Ball Joint Set is a front ball joint set for Ford F250 and F350 trucks with Dana super 60 axles. Confirm the model year before installing, since the year range for this set needs checking.
The joints are built to the same standards as Dana Spicer’s OE supply.
Key features
- Front position, per the stated copy
- Dana super 60 axle type
- Fits Ford F250 and F350 trucks
- Identified by brand Dana Spicer and UPC 23913149123
Ford super 60 front ends
On a front axle with a super 60 housing, ball joints work alongside the steering knuckle, tie rods and drag link to keep the wheels pointed and rolling smoothly. Heavy-duty trucks put more load through these joints, so a worn joint can produce a shimmy, a wandering feel or a clunk when turning. Check for play with the wheel off the ground and a helper rocking the tire, and look for torn boots or dry grease.
Because a set can involve both upper and lower joints, decide whether to replace both at once. Mixed wear on one side often shows up as uneven tire wear, so inspect the opposite side as well. When pulling old joints, use the proper separator to avoid damaging the knuckle bore. After installation, have the front end aligned and recheck the steering components after the first short drive.
Specifications
| Brand | Dana Spicer |
|---|---|
| Position | Front |
| Axle type | Dana super 60 |
| Stated vehicles | Ford F250 and F350 |
| Stated years | 2005 to 2001 (as written) |
| UPC | 23913149123 |
Vehicle fitment
Both direct fit and universal fit labels apply, so confirm the axle match before installing.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replacing front ball joints means separating the steering knuckle, and a front-end alignment check usually follows the work.
What’s included
This is sold as one ball joint set.









