Overview
The Dana Spicer 700238-2X is a ball joint kit for Ford Dana 50 and Dana 60 axles, fitting 1992-2007 Dana 60 and 1999-2001 Dana 50 applications. Each kit covers one side only, so a second kit is needed for the opposite side of the axle.
These replacement joints match the factory units and are designed for 100,000 miles plus of service in many applications. The kit is not lubeable.
Key features
- One upper and one lower ball joint in every kit
- Sold for one side only
- Not lubeable design
- Dana Spicer describes them as the same ball joints fitted at the factory
After the ball joints are replaced
Ball joints carry the weight of the front wheel and let the knuckle pivot for steering, so wear here changes how the truck tracks and steers. Common signs include a clunk over bumps, wandering on the highway, uneven tire wear on the inner or outer edges, and play that can be felt when the wheel is rocked at the top and bottom. Because each side is separate, joints are often replaced in pairs on the same axle.
Installing new joints changes the front-end geometry at the knuckle, so an alignment check is part of the job. Look at the steering linkage, tie rods and track bar while the knuckle is apart, since worn parts there can affect the new joints and steering feel. Keep the dust boots clean and free of tears during assembly. If the truck has a locking hub, confirm it still engages correctly after the work.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 700238-2X |
| UPC | 23913147563 |
| Axle types | Dana 50, Dana 60 |
| Listed applications | 1992-2007 Ford Dana 60; 1999-2001 Ford Dana 50 |
| Included | 1 upper ball joint, 1 lower ball joint |
| Side | One side only |
| Lubeable | Is not lubeable |
Vehicle fitment
No vehicle-by-vehicle fitment list is available for this kit. The stated applications name Ford Dana 60 and Dana 50 axles with years, not a full vehicle model list, so confirm the axle type and year on your truck before installing.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Ball joint replacement changes the front-end geometry at the knuckle, so expect a front-end alignment check after the new joints are in.
What’s included
One upper ball joint and one lower ball joint for one side of the axle.
Not included: the opposite side’s ball joints, which need a second kit.









