Overview
The Dana Spicer 40583 is a Dana 30 ball joint for the front axle, fitting Dana 30 TJ and Dana 30 Reverse axle types. Confirm the joint position, upper or lower, before installing it.
The joint is designed to match factory units. It is not lubeable.
Key features
- Replacement ball joint for front Dana 30 axles
- Listed axle types: Dana 30 TJ and Dana 30 Reverse
- Not lubeable design
- Part number 40583 from Dana Spicer
Choosing and checking the joint
A Dana 30 front axle uses ball joints to pivot the knuckle, and wear shows as looseness at the wheel or a vague steering feel. Before installing a replacement, confirm whether the joint is upper or lower, since the position affects how it loads the knuckle and where it seats. Measure the old joint’s stud and housing against the new one.
Because this joint is not lubeable, service life depends on the boot and seal, so inspect them whenever the knuckle is off. Replace the opposite side’s joint if it shows play, and plan a front-end alignment after any joint change. Confirm the axle type before buying, since the axle decides the match more than the universal fit label does.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 40583 |
| Axle location | Front |
| Axle type | Dana 30 TJ, Dana 30 Reverse |
| Joint position | |
| Lubeable | Is not lubeable |
| Fitment label | Universal fit |
Vehicle fitment
No vehicle-by-vehicle fitment list is available. The stated axle types are Dana 30 TJ and Dana 30 Reverse, and the universal fit label does not replace an axle type check. Use the axle type on your truck to confirm the match.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Settle the joint position before installing, because the title and specifications disagree. Expect a front-end alignment check after the swap.
What’s included
One ball joint is described. No other parts are named.









