Overview
The Baer Brakes 6801170 is a 6P front caliper rebuild kit that services one front 6P brake caliper. It supplies the seals, pad abutment clips, banjo crush washers and a bleeder dust cap for overhauling that caliper, with O-rings for pistons of 1.625, 1.375 and 1.1875 inch diameter.
Only one caliper is serviced per kit, and it is for the front position. Confirm the caliper type and piston sizes against your existing caliper before ordering.
Key features
- EPDM rubber pressure and weather seals
- Stainless steel brake pad abutment clips
- New banjo crush washers and a bleeder dust cap
- Services one front 6P caliper per kit
- Square-rim O-rings with 1.1875, 1.625 and 1.375 inch inside diameters
- Pressure seals, weather seals and pad abutments included
Front caliper service tips
Front calipers do most of the stopping work and often run hotter than rear units, so their seals and bores see more heat cycling. A rebuild is most useful when a caliper sticks, leaks at the piston or bleeder, or pulls to one side. Before taking the caliper apart, note how the pads sit and how the slide pins move so reassembly is easier.
Pad abutment clips and slide pins are often replaced along with the seals. Clean old grease from the pins, then apply a brake-rated lubricant to the sliding surfaces and keep it off the piston seals. After the caliper is back in service, check the rotor face for scoring, since a sticking caliper often wears a rotor unevenly.
- Replace slide pin boots that are cracked
- Compare pad wear across both sides of the axle
- Bleed the system until the fluid runs clear of air
- Test the pedal before driving
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801170 |
| UPC | 90127959473 |
| Position | Front |
| Caliper type | 6P |
| O-ring inside diameter | 1.1875, 1.625 and 1.375 inch |
| O-ring material | EPDM rubber |
| O-ring rim shape | Square |
| Seal type | O-ring |
| Emission code | 6 |
| Pad abutments included | Yes |
| Pressure seals included | Yes |
| Weather seals included | Yes |
| Bleeder screw dust cap included | Yes |
| Bleeder screw included | No |
| Package type | Kit |
| Country of origin | USA |
Vehicle fitment
It is identified by the 6P caliper type and the front position. Match your front caliper to those details before choosing it.
The 6P caliper type is the only one named, so other caliper types fall outside this kit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the O-rings are sized to specific bores, check each piston’s diameter before selecting which seal goes where. Take the front caliper apart completely and clean every bore before fitting seals. Reuse a serviceable bleeder screw, since none comes in the box. A failed brake caliper can cause a loss of braking, so a qualified technician should do the rebuild if hydraulic work is new to you.
What’s included
This box holds pressure and weather seals, abutment clips in stainless steel, banjo crush washers and a bleeder dust cap, all for one front 6P caliper.
Not included: The bleeder screw. Brake pads and the caliper body are not part of this kit.











