Overview
The Warrior 800061 is a set of leaf spring shims for correcting pinion and/or caster angles on leaf sprung Jeep and truck axles. It corrects a 4 degree angle and is designed to be permanently attached to the leaf spring pack using the leaf’s cross-pin.
Shims of this type change the angle of the axle relative to the driveshaft, which is why they are used when pinion or caster angles fall out of range after a spring change. The cross holes are counter-bored against the angled surface so the cross-pin clamps with even force across the top of the pin. Warrior uses steel construction to help the shim hold up under heavy load.
Key features
- Corrects pinion and/or caster angles on leaf sprung axles
- Counter-bored cross holes seat against the angled surface of the shim
- Cross-pin clamping force spreads evenly across the top of the pin
- Steel construction for heavy load conditions
- The design resists spinning out of place, falling out or breaking under load.
Before you fit leaf spring shims
Leaf spring shims sit between the spring and axle, so the fitting and the cross-pin work together to hold the correction in place. A loose or misaligned pin can let the shim move under load, which changes the angle you worked to set. Clean the leaf and pin surfaces before assembly and make sure the counter-bored holes seat fully against the angled face.
Once a spring pack is replaced or the vehicle is lifted, the driveline angles may need another look. Shims are often one part of a larger correction that includes spring rate, pinion position and control arm geometry. Take measurements again after the first few weeks of driving, since settling springs can shift the picture.
- Clean the leaf and cross-pin surfaces before assembly
- Check that the cross-pin sits fully against the shim face
- Measure driveline angles again after the first few weeks
- Note any new vibration and recheck the angles promptly
Specifications
| Brand | Warrior |
|---|---|
| Part number | 800061 |
| UPC | 634146800615 |
| Material | Steel |
| Correction angle | 4 degree |
| Center pins | Without center pins |
| Fit type | Universal Fit |
Vehicle fitment
The shims are universal fit for leaf sprung Jeep or truck axles and are not tied to a specific vehicle year, make or model. Because each shim corrects a specific angle, the 4 degree correction must match what your leaf spring setup needs.
Pinion and caster angle requirements vary by setup, so measure your current angles and confirm the needed correction before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shims attach permanently to the leaf spring pack through the leaf’s cross-pin. Confirm the 4 degree correction matches your angle requirement before fitting them, since they are a permanent attachment and not a removable part.
What’s included
Warrior leaf spring shims, part number 800061, with the 4 degree correction described above.
Not included: Center pins are not included. Confirm the quantity in your package before planning the installation.








