Overview
The Warrior 800052 leaf spring shim is a 6 degree steel shim for correcting pinion and caster angles on a leaf sprung Jeep or truck. It is designed to be permanently attached to the leaf spring pack through the leaf’s cross-pin.
The cross holes are counter-bored against the angled surface so the cross-pin receives even clamping force across the top of the pin. The steel build is intended to help the shim hold up under heavy loads and stay in place without spinning out or falling out. Because the shim changes an angle on a specific setup, confirm fit against your axle and spring before use.
Key features
- 6 degree angle correction
- Heavy-duty steel construction
- Counter-bored cross holes for even clamping force
- Attaches permanently to the leaf spring pack through the cross-pin
- Without center pins
Choosing the right correction
Pinion and caster angles change how the driveline and steering geometry work together, so a leaf spring shim is usually a tuning step rather than a simple add-on. Before buying one, measure the current pinion angle and caster with the suspension at its working height. Pick a correction that moves the angle toward the range your driveline needs, and remember that one shim can only correct so much.
Shims are often rechecked when spring packs are rebuilt, when a lift is added, or when a new axle goes in. Worn leaf springs can shift the angle over time, so vibration or driveline noise at speed is a reason to measure again rather than assume the shim is still doing its job. Inspect the cross-pin and shim faces for cracks, bright wear marks or movement at every service.
- Check the cross-pin for wear before fitting a new shim
- Recheck angles after any spring or lift change
- Look for cracks or movement at the shim faces
- Re-torque clamping hardware after the first few drives
Specifications
| Brand | Warrior |
|---|---|
| Part number | 800052 |
| UPC | 634146800523 |
| Material | Steel |
| Degree | 6 degree |
| Center pins | Without center pins |
| Fitment type | Universal fit |
Vehicle fitment
This is a universal fit shim and is not tied to a particular year, model or axle make. Because it corrects a pinion or caster angle, match its 6 degree correction to the angle your setup needs before choosing it.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Changing pinion or caster angles affects driveline angles, so have the alignment and driveline checked after installation.
What’s included
The shim comes without center pins. Check the package contents against your installation before starting.






