Overview
The Pro Comp degree shim 99-400B, part number 99-400B, is a tapered 4 degree shim sold as a pair. Pro Comp Suspension designs it to improve the vehicle’s driveshaft angle, and it is listed without center pins.
The shim is tapered, so its thickness changes across its length, and that taper sets the angle it corrects. The UPC for this part is 614901170146.
Key features
- Tapered 4 degree design
- Sold as a pair
- Without center pins
- Designed to improve driveshaft angle
Measuring driveshaft angle
Driveshaft angle is the number that decides whether a shim helps or hurts. Measure it on the truck under its normal load, using a driveline angle gauge at the pinion and transmission or transfer case, then compare the readings to decide how much correction is needed.
Because the shim is tapered, its orientation matters as much as its degree. Mark the orientation before loosening any fasteners so the shim can be returned to the same position if the measurement is repeated. Re-measure after installation to confirm the angle has moved in the right direction.
Shims are usually one part of a larger driveline setup, so check U-joint wear and pinion condition when the angle is off by a large amount.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 99-400B |
| UPC | 614901170146 |
| Degree | 4 degree |
| Quantity | Pair |
| Center pins | Without center pins |
Vehicle fitment
No vehicle is named for this shim pair. Choose the angle from a driveline measurement on the truck, since a shim that is too steep or too shallow will not correct the angle.
Installation notes
Install the shims with the taper oriented to correct the angle you measured, and confirm the axle pinion angle after installation. Check that the U-bolts are tightened to specification once the setup is complete.
What’s included
The package is a pair of shims without center pins.










