Overview
The Trail Gear 186024-KIT is a left hand thread rod end kit with a 5/8 inch bore. Heim joints like this one sit at the ends of steering and suspension links and let the link pivot. The body is 100% 4340 chromoly with a zinc finish, and the ball is AISI 52100 material that is hard chrome-plated. Trail Gear marks it universal fit, and it comes with the jam nut.
Key features
- Body of 100% 4340 chromoly with zinc coating
- AISI 52100 ball with hard chrome plating
- Teflon liner
- Jam nut included
- Left hand thread direction
Care and wear checks
A heim joint is a ball set into a housing, and it lets the link pivot while carrying side loads. The ball and liner are the parts that wear first. Over time the liner loses its slickness, play builds at the ball, and the joint starts to click or bind when the suspension articulates. Check for this by hand before a trail run, with the link loaded and unloaded.
Because this kit has a left hand thread, adjust the length by turning the rod end in the same direction the joint came out. Set the length first, then tighten the jam nut against the housing so it stays put. Re-check the jam nut after the first few trail runs, since vibration is what usually backs it off.
- Check the ball for play by hand at every service
- Replace a joint that binds or clicks under load
- Keep the threads clean and lightly greased
- Match the thread direction on both ends of the link
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 186024-KIT |
| UPC | 70000621640 |
| Body material | 100% 4340 Chromoly |
| Body finish | Zinc coating |
| Ball material | AISI 52100, hard chrome-plated |
| Liner | Teflon |
| Bore | 5/8 inch |
| Thread direction | Left hand |
Vehicle fitment
It is a universal fit rod end. The left hand thread means it will not match a right hand joint, so check the thread direction of the joint being replaced.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the thread is left hand, confirm the existing link uses the same direction before threading the joint in. Set the jam nut only after the length is right.
What’s included
The kit comes with the rod end and the jam nut.









