Overview
The RockJock 4×4 CE-9114N is a narrow body forged Johnny Joint rod end with a 1 1/4″-12 right hand threaded shank, made for custom builds. Each unit comes fully assembled with standard Johnny Joint internals, a 2.365″ ball center width and a .5625″ thru bolt hole, finished in gold zinc plating.
It is a universal fit joint, not built for one make, model or year. Measure your mounting points and link length before you order.
Key features
- Forged narrow body rod end in forged steel
- 1 1/4″-12 right hand threaded shank
- Fully assembled with standard Johnny Joint internals
- Externally greasable through a zerk fitting
- 2.365″ wide ball center and .5625″ thru bolt hole
- Gold zinc plating finish
Choosing a Johnny joint setup
A Johnny joint lets a link swing through a range of angles while the ball stays seated in its housing. On a custom build, the joint’s position and the link angle often matter as much as the part itself. A narrow body suits tight mounting points where a wider joint would strike the frame or a tube.
Start by matching the thread direction and size to your tube or bar, then check the ball width against your bracket. Plan on replacing the jam nuts and any sleeves together with the joint when you rebuild the link, since worn hardware is a common reason a fresh joint loosens.
- Thread direction and size against the tube or bar
- Ball width against the mounting bracket
- Clearance at full steering and suspension travel
Specifications
| Brand | RockJock 4×4 |
|---|---|
| Part number | R/JCE-9114N |
| Style | Narrow body forged Johnny Joint rod end |
| Material | Forged steel |
| Shank thread | 1 1/4″-12, right hand |
| Ball center width | 2.365″ |
| Thru bolt hole | .5625″ |
| Lubrication | External zerk fitting |
| Finish | Gold zinc plating |
Vehicle fitment
It is a universal fit part and is not sized for a specific vehicle, so compatibility depends on your own axle, link and mounting dimensions.
No specific make, model or year applies to this joint. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The joint is greasable through its external zerk fitting, so keep the grease point accessible after installation and check that the joint moves freely before you run the vehicle.
What’s included
One fully assembled narrow Johnny Joint rod end with standard Johnny Joint internals.
Not included: jam nuts. Matching jam nuts are offered by RockJock 4×4 as a separate item.









