Overview
The Trail Gear inspection hole kit, part number 140184-1-KIT, is an extra-large differential fill and inspection cap for axle housings. It is designed to give quick access to the ring gear for inspection, so the differential cover does not have to be removed for a check.
The kit provides a 1.5-inch access hole with a threaded aluminum cap that uses a rubber O-ring for a tight seal. It is sold for Toyota applications, covering the 1984–1995 Toyota 4Runner (DLX and SR5) and the 1979–1995 Toyota Pickup in its base, turbo, DLX and SR5 versions.
Key features
- Extra-large fill and inspection cap for quick ring gear checks
- 1.5-inch diameter access hole
- Threaded aluminum cap with a rubber O-ring seal
- Threaded bung for welding onto the housing
- Available loose for a do-it-yourself install, or pre-installed in a housing ordered at the same time
Checking the ring gear safely
A ring gear check through an access hole is faster than removing the differential cover, but the housing still needs to be kept clean and sealed. Before opening the cap, wipe away mud and grit around the hole so debris does not drop into the gears. Keep the cap and O-ring clean and free of damage.
Welding a bung onto a housing changes the housing, so plan the work with the axle out of the vehicle if possible and allow the weld area to cool before sealing. Gear oil level is worth checking after the install, and the cap should be snug without over-tightening the threads.
- Inspect the O-ring for flattening or cracks each time the cap is removed
- Check gear oil level after installation and after any water crossing
- Keep the weld area clear of debris before fitting the cap
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 140184-1-KIT |
| UPC | 70000621504 |
| Access hole | 1.5 inch diameter |
| Cap | Threaded aluminum with rubber O-ring |
| Installation | Welding required |
| Kit contents | One threaded bung, one cap and one O-ring |
Vehicle fitment
It fits the 1984–1995 Toyota 4Runner (DLX and SR5) and the 1979–1995 Toyota Pickup (Base, Base Turbo, DLX, DLX Turbo, SR5 and SR5 Turbo).
Toyota models and years outside those listed above, and differentials other than the housing named here, are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting a hole into the top of the differential housing and welding on the threaded bung, so this kit is best fitted by a shop with welding experience. The cap then screws into the bung and seals with the O-ring.
What’s included
One threaded bung, one aluminum cap and one O-ring, part 140184-1-KIT.









