Overview
The G2 CORE 44 rear axle housing, part number 67-2052JKR, is a bolt-in replacement rear axle for the Jeep JK Wrangler built for 2007 and later models. It uses a high-pinion Dana 44 design built to handle heavy loads that would bend a stock rear axle.
The housing uses metric carrier bearings, which allow the factory air locker to be used. It accepts stock Dana 44 ring and pinion sets, axle shafts and aftermarket lockers. The housing arrives bare, so gears, axle shafts and lockers are fitted separately.
Key features
- Rear bolt-in replacement housing for JK Wranglers
- High-pinion Dana 44 gear design
- Metric carrier bearings that allow use of the factory air locker
- Three-inch heavy-duty tubing to resist bending
- CNC-formed brackets laser cut from steel for bolt-in installation
- Spanner nuts for setting backlash, and an adjuster nut system for carrier pre-load
- Heavy-duty forged bearing caps
Setting up a bare axle housing
A bare housing needs the ring and pinion, carrier, bearings, axle shafts and brakes fitted before it goes under the vehicle. Pinion depth, backlash and carrier preload all affect gear life, so these settings should be made with care and checked after installation. The bearing caps and spanner nuts are the adjustment points.
Plan for the rest of the rear end as well. Axle shafts, brake parts, a locker and a gear set are typically bought together, and each part has to match the Dana 44 layout. Check that the housing and gears are matched before final assembly, and keep a setup record for later service.
- Set pinion depth before final assembly
- Check backlash with a dial indicator
- Confirm carrier preload after installation
- Match axle shafts and brakes to the Dana 44 layout
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 67-2052JKR |
| UPC | 631410112733 |
| Position | Rear |
| Housing type | CORE 44, Dana 44 high pinion |
| Carrier bearings | Metric |
| Tube diameter | 3 inches, heavy-duty DOM tubing |
| Installation | Bolt-in |
Vehicle fitment
The housing fits 2007 through 2018 Jeep JK Wranglers in 2-door and Unlimited body styles. Wrangler TJ, LJ and JL models are not covered by this housing. Verify the year, model and trim against your truck before you order.
Wrangler TJ, LJ and JL models are not covered by this housing, and neither is any rear axle other than the Dana 44 layout described. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the housing comes bare, the ring and pinion, axle shafts, lockers and brakes must be fitted to it before it is put on the vehicle. The bearing caps and the spanner nuts are the points where backlash and carrier pre-load are set, so the setup should be checked after installation.
What’s included
One bare rear axle housing, part 67-2052JKR.
Not included: the ring and pinion gears, axle shafts, lockers and brakes, which are installed separately.




















