Overview
The Trail Gear 140317-1-KIT is a right-hand drop front axle housing kit for the 1995–2004 Toyota Tacoma in Base, Limited, Pre Runner, S-Runner and SR5 trim.
The axle tubes are offset above the centerline, so the inner axles ride low in the tubes and add 3/8 in. of ground clearance under the tubes. Knuckle balls are forged from 1035 steel. The axle tubes are 5/16 in. thick DOM steel, 1020 DOM, with a 3 in. outer diameter.
Key features
- Right-hand drop front axle housing
- Offset axle tubes for added ground clearance
- Forged 1035 steel knuckle balls
- 5/16 in. thick DOM axle tubes with a 3 in. outer diameter
Installing an axle housing
A drop axle housing changes where the axle tubes sit relative to the frame, so the position of the inner axles and the driveline angles both shift. Before starting, support the vehicle securely, drain any fluid that will be disturbed, and mark the existing hardware so reinstalled parts go back in the right place. Offset tubes that ride low can rub on brackets or skid plates, so check clearance after assembly.
Driveshaft angles should be checked after installation, since a lower axle position can increase joint angle and cause vibration. Inspect the joints, boots and mounting hardware after the first drives, and recheck fastener torque. Ground clearance gained at the tubes is only part of the picture, because the differential and skid plates also determine how the vehicle clears obstacles on the trail.
- Support the vehicle before removing any parts
- Mark hardware positions before disassembly
- Check clearance to brackets after assembly
- Inspect joints and boots after the first drives
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 140317-1-KIT |
| UPC | 70000621665 |
| Front or rear | Front |
| Drop | Right-hand (RH) |
| Housing type | Toyota |
| Axle tube | 5/16 in. thick, 3 in. outer diameter, 1020 DOM steel |
| Knuckle balls | Forged 1035 steel |
| Ground clearance gain | 3/8 in. under the axle tubes |
Vehicle fitment
It fits the 1995–2004 Toyota Tacoma in Base, Limited, Pre Runner, S-Runner and SR5 trim. Tacoma years from 2005 onward and the 1979–1995 Toyota Pickup and 4Runner are not covered.
Tacoma years from 2005 onward, and the 1979–1995 Toyota Pickup and 4Runner, are not on this list.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The kit is a right-hand drop front axle housing. Check the package contents against your installation before starting.








