Overview
The Trail Gear 1.25 Inch Creeper Joint, part 110762-KIT, is a left-hand thread finished joint for flexible suspension links, supplied with a jam nut. The forged shell is built to handle years of hard use.
Inside, an 8620 tool steel flex ball rides on high quality polyurethane bushings, and heavy-duty hardened steel washers hold the joint together. Trail Gear states up to 40 degrees of movement when spacers are used.
Key features
- Forged single-piece outer shell
- Left-hand thread
- 8620 tool steel flex ball
- High quality polyurethane bushings
- Hardened steel washers
- Cross lubrication through the flex ball, with grease fitting on top
Checking the link before fitting
A creeper joint sits at the end of a flexible suspension link and lets that link pivot as the axle moves through articulation. On the trail, that pivot keeps the link working under load instead of binding a mount or bending a bracket. Joints like this one are judged by thread direction, length, bolt size and how far the ball can travel before it reaches the mount.
Before fitting, measure the existing link end and compare its thread direction, length and bolt size with the joint. Because the joint is serviceable, check the flex ball, bushings and washers for play after every few outings. Re-tighten the jam nut once the length is set, and grease the joint until fresh grease shows at the seals.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 110762-KIT |
| UPC | 70000621325 |
| Size | 1.25 inch |
| Joint details | Finished joint |
| Type | Forged |
| Maintenance | Serviceable |
| Thread direction | Left |
| Flex ball material | 8620 tool steel |
| Bushings | Polyurethane |
| Washers | Hardened steel |
| Articulation | Up to 40 degrees with spacers |
Vehicle fitment
It is a universal fit part, not matched to a particular vehicle, model or year.
Check the link and mount you plan to use. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the joint is a left-hand thread, confirm the link it goes into uses a matching left-hand thread before assembly. The grease fitting on top is the lubrication point for the whole joint.
What’s included
One finished left-hand joint with a jam nut.
Not included: Spacers, which are needed to reach the 40 degree movement figure.








