Overview
The 110773-KIT is a 1 inch creeper joint, a forged heavy-duty rod end with right-hand thread for flexible suspension links. Rod ends like this, also called heim joints, let a link pivot through a wide arc, which matters on suspension setups that flex hard off-road. The link end size and mounting points should be checked against your own suspension before installation.
The outer shell is a single forged piece. Inside, the 8620 tool steel flex ball turns on polyurethane bushings, and hardened steel washers hold the joint together. The joint is serviceable, so it can be greased rather than replaced when it wears.
Key features
- Single-piece forged outer shell
- Inner flex ball of 8620 tool steel
- Polyurethane bushings and hardened steel washers
- Up to 40 degrees of movement when used with spacers
- Threaded grease fitting on top of the joint
- Flex ball drilled for cross lubrication from the shell to the link mount bolt
- Serviceable design with a jam nut included
Rod end inspection and care
Rod ends fail gradually. The first signs are play when the link is rocked by hand, a knocking sound over bumps, and a grease fitting that no longer pushes fresh grease. Inspect the joint at each service, and check that the jam nut is tight and the threads on the shank are undamaged.
Replacing a worn joint is often easier than rebuilding a link, but both options start with checking the link end and mounting hardware. Bushings and washers wear on a similar schedule, so inspect the ball and shell for scoring before deciding. When spacers are used, check they are not bottoming out against the mount.
- Grease through the top fitting after trail use
- Look for cracks around the forged shell
- Check the link mount bolt for looseness
- Replace the joint when play cannot be removed by adjustment
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 110773-KIT |
| UPC | 70000621322 |
| Joint size | 1 inch |
| Joint details | Finished joint |
| Type | Forged |
| Thread direction | Right |
| Outer shell | Single forged piece |
| Flex ball | 8620 tool steel |
| Bushings | Polyurethane |
| Washers | Heavy-duty hardened steel |
| Movement | Up to 40 degrees with spacers |
| Maintenance | Serviceable |
Vehicle fitment
The joint is not matched to specific vehicles and carries a universal fit label. Fit depends on the thread, bolt size and mounting points of the link and bracket it replaces, not on the vehicle’s year or model alone.
No specific year, make or model is confirmed for this joint. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a right-hand thread joint, so match the thread direction to the link end you are replacing. Use the included jam nut to lock the joint once it is set, and lubricate through the grease fitting on top. The 40-degree movement figure applies when spacers are used.
What’s included
Each joint includes a jam nut, and a threaded grease fitting is provided on top of the joint.
Not included: The link, mount, bolts and spacers are not included with this joint.








