Overview
The Trail Gear 110776-KIT is a 1 inch forged creeper joint with left-hand thread, built as a heavy-duty rod end for flexible suspension links. Rod ends pivot a link at its mount, and this joint is made for hard use in suspension setups that articulate heavily.
A single forged piece makes up the outer shell. The flex ball is 8620 tool steel, supported by high-quality polyurethane bushings, and heavy-duty hardened steel washers keep the joint assembled. A threaded grease fitting on top allows lubrication, and the flex ball has a cross-drilled passage that carries grease from the shell to the link mount bolt.
Key features
- Forged one-piece outer shell
- 8620 tool steel inner flex ball
- Polyurethane bushings
- Hardened steel washers
- Up to 40 degrees of movement with spacers
- Cross-drilled flex ball for grease flow to the link mount bolt
- Serviceable joint with threaded grease fitting
Left-hand thread considerations
Left-hand thread joints are found on the opposite side of some links, and mixing thread directions is a common mistake when replacing parts. Before buying, confirm the thread on the link end you are removing and note whether it is marked. A joint installed in the wrong direction will not thread on correctly and should never be forced.
Once the thread matches, set the joint length to the desired geometry, then lock it with the jam nut. Grease the flex ball through the top fitting after setting the joint, and confirm the cross-drilled passage carries grease to the link mount bolt. Recheck the adjustment after the first few trail runs.
- Measure the old joint’s thread before ordering
- Clean the threads before installing
- Use the jam nut to lock adjustment
- Inspect the joint after each season of hard use
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 110776-KIT |
| UPC | 70000621319 |
| Joint size | 1 inch |
| Joint details | Finished joint |
| Type | Forged |
| Thread direction | Left |
| Outer shell | Single forged piece |
| Flex ball | 8620 tool steel |
| Bushings | Polyurethane |
| Washers | Heavy-duty hardened steel |
| Movement | Up to 40 degrees with spacers |
| Maintenance | Serviceable |
Vehicle fitment
This joint is labeled Universal Fit and is not matched to any specific vehicle. Whether it works depends on the link end size, thread and bolt pattern of the arm it replaces, so the vehicle’s year and model alone do not settle fit.
This joint is not matched to a specific year, make or model. Confirm fit for your vehicle, then compare the link end size with the joint you are replacing.
Installation notes
Because the thread is left-hand, check that the link end you are replacing also turns left before installing. Grease the joint through the top fitting once it is in place, and use the included jam nut to lock the adjustment.
What’s included
Each joint includes a jam nut, and a threaded grease fitting is provided on top.
Not included: Link arms, mount hardware and spacers are not included.









