Overview
The Currie CE-9115B is a right hand, weld-in threaded bung with a matching jam nut, designed for forged Johnny Joint rod ends or any other 7/8 inch thread rod end.
The hex shape, rather than round, makes bar adjustment easier, and a 1-3/8 inch wrench fits the hex. The bung is sized to fit a tube with a 1-1/4 inch inside diameter.
Key features
- Right hand 7/8 inch -18 thread
- Weld-in bung for Johnny Joint and 7/8 inch rod ends
- Hex shape for bar adjustment
- Custom machined jam nut included, same hex size
- Designed for a tube with 1-1/4 inch inside diameter
Preparing a weld-in bung
A weld-in bung is fixed permanently to a tube, so fit and preparation matter before any heat is applied. Clean the tube and the bung where the weld will sit, removing paint, rust and oil that can make the weld porous. Position the bung square to the tube so the threads line up with the joint’s intended travel. Tack it in place and confirm alignment before running the full weld.
Heat can distort threads, so check the bung with the jam nut after the weld cools and clear any spatter that could interfere. A hex bung makes it easier to hold steady with a wrench while the adjustment is set. Use a welder experienced with the tube material and the bung’s construction, and inspect the finished weld for cracks before putting the joint into service. Keep the mating rod end clean and lightly greased to reduce wear in the threads.
Specifications
| Brand | Currie |
|---|---|
| Part number | CE-9115B |
| UPC | 817783000420 |
| Thread size | 7/8 in – 18 |
| Thread direction | Right hand |
| Hex wrench size | 1-3/8 inch |
| Tube inside diameter | 1-1/4 inch |
| Jam nut | Included, custom machined, same hex size as the bung |
| Fitment | Universal fit |
Vehicle fitment
This bung is a universal fit part, not a vehicle-specific one, and fit depends on the rod end and tube size.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This bung is weld-in, so it is welded into the tube rather than bolted on. Use a tube with a 1-1/4 inch inside diameter and have a qualified welder do the job.
What’s included
A right hand weld-in bung and a custom machined jam nut with the same hex size.









