Overview
The Trail Gear 110136-1-KIT is a 3/4 inch -16 right hand weld-in bung with a threaded tube adapter body, built for Heim and Johnny Joint rod ends. It has a 1 inch minimum tube ID and is a universal fit.
Weld-in means the bung is fixed to the tube by welding. Confirm the right hand thread matches your joint before you weld.
Key features
- 3/4 inch -16 right hand thread
- 1 inch minimum tube ID
- Weld-in design for Heim and Johnny Joint rod ends
- Universal fit
- Jam nut not included
Choosing a weld-in bung
A weld-in bung gives a rod end a threaded seat on a tube, so the strength of the joint depends on the weld as much as the thread. Before buying, measure the tube inside diameter and confirm it is at least the minimum for this bung. Thread direction matters too: a right hand thread must match the right hand rod end you are installing, and mixing directions causes the joint to bind or back out.
Because the bung is set into the tube, rod ends are often replaced at the same time. Inspect the tube around the weld periodically for hairline cracks, bending or heat discoloration, especially after rough trail use. Keep threads clean and lightly greased so the jam nut can be backed off when adjusting length or replacing a joint.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 110136-1-KIT |
| UPC | 70000621490 |
| Thread size | 3/4 inch -16 |
| Thread direction | Right hand |
| Minimum tube ID | 1 inch |
| Jam nut | Not included |
| Fitment | Universal fit |
Vehicle fitment
It is a universal fit, so the joint thread and tube size decide whether it works for your build.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the bung is welded in, have a qualified fabricator handle the job on a tube that meets the 1 inch minimum ID.
What’s included
The threaded tube adapter bung.
Not included: Jam nut.









