Overview
Trail Gear’s 110124-1-KIT is a left hand, 1 inch -14 weld-in threaded bung for Heim and Johnny Joint rod ends. It is listed with a 1 inch minimum tube ID and as universal fit, so it is not tied to any one vehicle.
The jam nut is not part of this kit. Check the left hand thread against your rod end before the bung is welded in place.
Key features
- Left hand 1 inch -14 thread
- 1 inch minimum tube ID
- Weld-in for Heim and Johnny Joints
- Universal fit
- Jam nut not included
Left hand threads in use
Left hand threads are less common than right hand threads on rod end hardware, so they are often used where a joint needs to tighten in the opposite rotation to the rest of the linkage. Before welding, confirm which direction the joint turns onto the bung, because a mismatch can loosen the adjustment instead of holding it. Label the tube and parts during assembly so the orientation stays clear.
Weld-in bungs depend on a sound joint between the bung and tube. Clean the tube and bung surfaces, fit the bung square, and have a qualified fabricator weld it with a technique suited to the tube material. Once installed, check that the threads run cleanly and the joint turns freely before loading it on the trail.
- Confirm thread direction on both parts
- Clean weld surfaces before fitting
- Keep the bung square to the tube
- Recheck threads after the first trail runs
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 110124-1-KIT |
| UPC | 70000621487 |
| Thread size | 1 inch -14 |
| Thread direction | Left hand |
| Minimum tube ID | 1 inch |
| Jam nut | Not included |
| Fitment | Universal fit |
Vehicle fitment
This part is universal fit and is not written for a particular make, model or year.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A weld-in bung is fixed to the tube by welding, so a qualified fabricator should weld it on a tube with at least a 1 inch inside diameter.
What’s included
Threaded tube adapter bung, left hand.
Not included: Jam nut.









