Overview
The TeraFlex VSS rear shock absorber, part number 1544334, is a twin-tube gas shock for the 2004–2006 Jeep Wrangler (LJ) and 1997–2006 Jeep Wrangler (TJ), designed for a 3-4 inch lift. It is a rear position unit with a hydraulic shock type.
Triple-chromed rods support extended, trouble-free service. The shock uses premium quality rubber bushings with TJ attachments and a resistant black finish suited to heavy off-road use.
Key features
- Twin-tube gas design
- Triple-chromed rods
- Premium quality rubber bushings with TJ attachments
- Resistant black finish
- Rear position for a 3-4 inch lift
- Supplied individually
Measuring your lift before install
A shock designed for a 3-4 inch lift is built around the suspension height and travel of that range, so knowing your current lift matters before fitting. Measure from the axle to the frame at the rear and compare the result with the range the shock is designed for. A shock that is too short can bottom out on the bump stops, while one that is too long can limit droop and cause the axle to hang.
Lift type also affects fit. Coil spring spacers, leaf pack changes and axle blocks each shift the shock’s mounting angle differently. Note your current setup before ordering so you can match it to the shock’s intended application and avoid rework during install.
- Measure rear lift from axle to frame
- Note any spacers or blocks in place
- Compare results with the shock’s intended range
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1544334 |
| UPC | 843885022282 |
| Series | VSS |
| Position | Rear |
| Lift | 3-4 inch |
| Rod | Triple-chromed |
| Bushings | Premium quality rubber |
| Finish | Resistant black |
| Shock type | Hydraulic |
Vehicle fitment
Fitment shows 2004–2006 Jeep Wrangler (LJ) Unlimited and Unlimited Rubicon, and 1997–2006 Jeep Wrangler (TJ) 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X.
Wrangler years and generations outside these models, including JK and JL, are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure your current lift to check it falls within the 3-4 inch range this shock is designed for.
What’s included
One rear shock per unit. Check the package contents for mounting hardware before installing.









