Overview
The TeraFlex 4444401 is a short shaft slip yoke eliminator for the NP231 transfer case. It removes the slip yoke and, in most cases, removes the need to lower the transfer case. The kit adds 4 inch to rear drive shaft length and is built to handle the higher torque loads that come with extreme low-range gearing.
The kit uses a heavy duty shaft and includes a larger output bearing and rear housing. Fitment is shown for 1997 and 2000-2001 Cherokee XJ, 2004-2006 Wrangler LJ and 1997-2006 Wrangler TJ models in the fitment section.
Key features
- Eliminates the slip yoke
- Removes the need to drop the transfer case in most cases
- Engineered to withstand 50% more torque
- Heavy duty output shaft with a larger output bearing and rear housing
- Fixed 1310 CV style yoke
Checking driveline angles
Adding length to the rear driveshaft changes the angle at both u-joints, and that angle affects vibration and joint wear. Once the kit and new shaft are in place, check the joint angles with the vehicle at ride height and correct any imbalance before driving far. Lift height matters here too, because a taller suspension increases the angle at the transfer case end.
Speed reading and shaft balance should be checked after installation. A shaft that is out of balance can shudder at highway speeds, and worn joints tend to clunk when the throttle is applied or released. Address any new noise early, since a driveline that runs out of angle can wear the joints and the output bearing faster than expected.
- Check joint angles at ride height
- Balance the new shaft if vibration appears
- Inspect joints at each oil change
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 4444401 |
| UPC | 843885027836 |
| Transfer case | NP231 |
| Rear drive shaft length increase | 4 inch |
| Torque capacity | 50% increase |
| Replacement yoke | 1310 CV style |
| Tail shaft and output shaft | Included |
| Extension housing | Included |
Vehicle fitment
It fits these vehicles:
- 1997 and 2000-2001 Jeep Cherokee XJ (Classic, Country, Limited, SE, Sport)
- 2004-2006 Jeep Wrangler LJ (Unlimited, Unlimited Rubicon)
- 1997-2006 Jeep Wrangler TJ (65th Anniversary Edition, Rubicon, SE, Sahara, Sport, X)
1998 and 1999 Cherokee XJ models are not covered, and Wrangler YJ models do not fit. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The kit requires use of a CV style rear drive shaft, so plan the driveline before installing it. The 4 inch increase in driveshaft length changes the driveline geometry, so check driveline angles after installation.
What’s included
The kit includes a new tail shaft, a new output shaft, a new extension housing, a larger output bearing and a rear housing.
Not included: the CV style rear drive shaft, which the kit requires.













