Overview
The Rubicon Express RE1807 is a slip yoke eliminator (SYE) kit for NP231 and NP242 transfer cases. A slip yoke eliminator replaces the sliding slip yoke on the transfer case output with a fixed yoke, which removes the slip joint from the driveline.
A slip yoke output is less suited to off-road use and to the steeper driveline angles of a lifted Jeep. The kit converts the output to a fixed flange-style yoke for smooth, durable driveline operation. It is made for the Jeep Cherokee (XJ), Grand Cherokee (ZJ) and Wrangler (TJ).
Key features
- Converts the slip yoke output to a fixed flange-style yoke
- Drive flange machined from solid stainless steel for strength and corrosion resistance
- Drill and tap included for the output shaft modification
- Rubicon Express recommends a CV drive shaft (RE1898) on all lifts 3.5 inches and taller
- Designed for NP231 and NP242 transfer cases
Driveline angles on a lift
Lifting a Jeep increases the driveline angle between the transfer case and the axle. Steeper angles load the joints more and can cause vibration at speed. A slip yoke eliminator removes the slip joint from that path, which is why many lifted owners consider it when setting up the driveline.
Changing the output yoke affects the rest of the driveline. Shaft length, joint angles and front-to-rear balance all matter, so review them together rather than as a single part swap. Check the transfer case output seal after the change, because a worn seal can leak once the yoke surface is altered.
Keep the driveline clean and lubricated, and inspect the U-joints periodically, especially on a lifted vehicle. Look for play, rust or dry joints. Vibration that appears after a change in driveline angle often points to a joint or shaft that needs attention.
- Review driveline angles together
- Check the output seal for leaks
- Inspect U-joints for play or dryness
- Watch for vibration at highway speed
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1807 |
| UPC | 614901438970 |
| Transfer case | NP231 and NP242 |
| Yoke type | Flange style |
| Drive flange material | Solid stainless steel |
| Tail shaft | Factory output shaft is modified; no new tail shaft |
| Extension housing | Not included |
Vehicle fitment
It fits the 1997-2001 Jeep Cherokee (XJ), the 1996-1998 Jeep Grand Cherokee (ZJ) and the 1997-2006 Jeep Wrangler (TJ).
The list does not include the Grand Cherokee (WJ) or the Wrangler JK, or any Cherokee or Grand Cherokee years outside those listed. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This kit is not a bolt-on swap. It requires modifying the stock output shaft, and a drill and tap are included for that work.
What’s included
A flange-style replacement yoke and the modified-shaft hardware, with a drill and tap for the shaft work.
Not included: a new extension housing. The tail shaft is made by modifying the factory output shaft rather than replacing it.








