Overview
The Pro Comp NP231 tail shaft conversion kit, part number 4007, is a slip yoke eliminator for the NP231 transfer case. It replaces the tail shaft so a CV style driveshaft can be used, and it fits the 1987 to 1995 Jeep Wrangler (YJ).
The kit shortens the transfer case by 4 inches compared with stock, which allows a 4 inch longer CV style driveshaft. A shorter transfer case tail is designed to improve driveline alignment and reduce bind, friction and vibration. The kit is designed for a 5 inch front and rear lift height.
Key features
- Fits the NP231 transfer case only
- Mainshaft listed at 20 percent larger than the factory shaft
- Shortens the transfer case by 4 inches
- Includes a new tail shaft, output shaft and extension housing
- Uses a 1310 CV style replacement yoke
Driveshaft length and yoke choice
A longer driveshaft changes the balance of the driveline, so the shaft must be sized to the new transfer case position. Measure the distance between the yokes with the vehicle at ride height, and remember that a lift and a transfer case change both affect the length. A CV style shaft handles angle changes well, but it still needs the correct length and clean splines to avoid vibration.
Yoke fitment and seal condition matter as much as length. Inspect the output seal for leaks after installation, and check the fluid level in the transfer case once the job is done. Low or contaminated fluid can wear the shafts and bearings, so change it when the case is opened. Rebalance the driveshaft if vibration appears at highway speed.
- Measure the driveshaft length before ordering a new shaft
- Check transfer case fluid level after installation
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 4007 |
| UPC | 614901691542 |
| Transfer case model | NP231 |
| Replacement yoke | 1310 CV style |
| Mainshaft | 20 percent larger than factory |
| Length change | 4 inches shorter than stock |
| Includes | New tail shaft, output shaft and extension housing |
Vehicle fitment
The kit is for the NP231 transfer case and fits the 1987 to 1995 Jeep Wrangler (YJ) across the trim levels of those model years. It will not fit an NP207 in some models, so confirm the transfer case before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The drive shaft is sold separately, so the CV style driveshaft must be sourced to match the 4 inch longer length. Confirm the transfer case model is an NP231 before starting work, since the kit does not fit other units.
What’s included
The kit includes a new tail shaft, a new output shaft and a new extension housing.
Not included: The driveshaft is sold separately.







