Overview
The Rugged Ridge 18676.71 is a 3-wire speed sensor for the Mega Short slip yoke eliminator kit 18676.70 on NP231 transfer cases. It is a replacement for the 18676.72 sensor.
The speed sensor is designed to work with the Mega Short SYE, which Rugged Ridge sells as a complete slip yoke eliminator. This part covers the sensor only. Fitment is shown for Wrangler LJ, TJ and YJ models in the fitment section.
Key features
- 3-wire speed sensor design
- Designed to work with the Mega Short slip yoke eliminator 18676.70
- Replacement for 18676.72
- Transfer case model NP231
- Limited 5 year warranty
Speed sensor wiring
A vehicle speed sensor sends a signal that tells the vehicle how fast the transfer case output is turning, and that signal feeds gauges and some electronic functions. Because the sensor sits at the output, it is exposed to mud and road grime. Connectors that corrode or lose their seal can cause intermittent signal problems that often look like a bad sensor.
Before connecting the new sensor, inspect the harness for chafing and check the connector pins for corrosion. Route the wire clear of moving parts and the driveshaft. After installation, confirm the readings during a short drive and recheck the connection after the first few trail outings.
- Inspect connector pins for corrosion
- Route wiring away from the driveshaft
- Recheck the connection after the first outings
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 18676.71 |
| UPC | 804314123963 |
| Wires | 3 |
| Transfer case | NP231 |
| Compatible SYE kit | 18676.70 (Mega Short) |
| Replacement yoke | Not applicable |
| Warranty | Limited 5 year |
Vehicle fitment
It fits these vehicles:
- 2004-2006 Jeep Wrangler LJ (Unlimited, Unlimited Rubicon)
- 1997-2006 Jeep Wrangler TJ (65th Anniversary Edition, Rubicon, SE, Sahara, Sport, X)
- 1987-1995 Jeep Wrangler YJ (Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara, Sport)
Wrangler JK models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Match the three wires to the existing harness before connecting the sensor. Confirm the sensor works with the Mega Short SYE kit before the transfer case is closed up.
What’s included
One 3-wire speed sensor.
Not included: the Mega Short slip yoke eliminator 18676.70, which the sensor is designed to work with.








