Overview
The Rubicon Express NP231 Slip Yoke Eliminator Kit (part number RE1811) converts the NP231 transfer case from a slip yoke to a fixed yoke. It is designed for 1987–2006 Jeep models with NP231 transfer cases, where lifting the vehicle often causes driveline vibration. The kit allows a longer driveshaft with better operating angles, which helps reduce those vibrations, and it strengthens the transfer case with a heavy duty main shaft.
The kit allows a longer driveshaft with better operating angles, which Rubicon Express says helps eliminate those vibrations. It also strengthens the transfer case with a heavy duty main shaft.
Key features
- Converts a slip yoke to a fixed yoke
- 1-3/8 inch 32 spline heavy duty main shaft
- Shorter tailshaft for longer driveshaft and better operating angles
- Compatible with the factory speedometer and vacuum shift sensors
- 1310 CV style replacement yoke
- Advantage Lifetime Warranty.
Driveline angles after a lift
Lifting a Jeep changes the angle of the driveshaft, and a steep angle at the transfer case is one of the most common causes of vibration. A fixed yoke removes the slip yoke from the output, so the driveshaft length and angles can be set more precisely. Before driving, measure the angles at the transfer case and the axle to see where the driveline sits.
The transfer case is opened for this job, so it is a good time to inspect the output bearings, the seals and the rear output area. Replace any worn parts you find while the case is apart. After the conversion, road test the vehicle at highway speed and listen for vibration that changes with speed or load.
- Measure driveline angles after the lift
- Inspect the output bearings and seals while the case is open
- Road test at highway speed after installation
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1811 |
| UPC | 614901439007 |
| Transfer case | NP231 |
| Main shaft | 1-3/8 in, 32 spline |
| Replacement yoke | 1310 CV style |
| Tail shaft | Shorter tailshaft, included |
| Extension housing | Not included |
Vehicle fitment
The kit fits all 1987–2006 Jeep NP231 transfer cases. Confirm that your transfer case is an NP231 before installing.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit replaces the output housing, main shaft and rear output yoke, so the transfer case must be opened for the work. The kit includes a replacement output housing, but a new extension housing is not included, so check the kit contents before starting.
What’s included
The kit includes a replacement output housing, a heavy duty main shaft, a rear output yoke and the necessary hardware. A new extension housing is not included.











