Overview
The short shaft slip yoke eliminator replaces the slip yoke on an NP231 transfer case with a fixed 1310 CV style yoke and a new heavy-duty output shaft.
It is designed for extreme low-range use, and the new shaft is built to handle a 50 percent increase in torque from the Tera Low 231 reduction.
Key features
- Heavy-duty output shaft built to handle increased torque
- Larger output bearing and rear housing
- Replaces the slip yoke with a fixed 1310 CV style yoke
- Includes a new extension housing
- Increases the rear driveshaft length by four inches
Driveline length and yoke service
A slip yoke lets the driveshaft change length as the axle moves, and a fixed yoke removes that movement. Once the slip yoke is gone, the driveshaft length and the pinion and transfer case angles have to work together, so the driveline should be checked after the kit goes in. Vibration at speed is often the first sign that the angles need attention.
The output shaft seals and bearings should be inspected at regular intervals, since leaks from the transfer case can be hard to spot once the driveline is assembled. The yoke bore and splines should be checked for wear whenever the driveshaft is removed.
- Check driveline angles after installation
- Inspect output seals for seepage
- Confirm the rear driveshaft is the required length
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 4444402 |
| Transfer case model | NP231 |
| Replacement yoke type | 1310 CV style yoke |
| Included components | New output shaft and new extension housing |
| Driveshaft length change | Four inches longer |
Vehicle fitment
This kit is for 1984–2001 Jeep Cherokee (XJ) models.
Grand Cherokee and other Jeep generations are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit usually avoids lowering the transfer case, since the rear driveshaft is four inches longer. Check driveline angles after installation.
What’s included
A new heavy-duty output shaft, a 1310 CV style yoke, a larger output bearing and a new rear housing.
Not included: the rear driveshaft, which must be the longer length the kit requires.












