Overview
The TeraFlex High-Angle Rzeppa CV Rear Drive Shaft, part TER4612362, is a rear driveshaft for the 2012–2018 Jeep Wrangler JK two-door. It combines a CV joint’s smooth torque transfer with the angle tolerance of a U-joint style shaft, and TeraFlex built it for the extreme angles that come with larger lifts.
The shaft uses a Rzeppa CV joint with a high-angle boot and laser-welded carbon steel tubing. Each shaft is zeroed out at assembly for a centric fit, so the tube runs true at speed without added balance weights.
The joint is the part of the shaft that changes most when a lift raises the driveline angles. A Rzeppa CV joint is designed to keep the rotation smooth through those angles, which is why TeraFlex chose it for lifted JK builds with a lift of 3 inches or more. The fitment entry covers two-door JK models for 2012 through 2018, and the shaft is built for the rear position on those vehicles.
Key features
- Rzeppa CV joint with a high-angle boot
- Laser-welded carbon steel tube at 2-3/8 inches
- Assembled to run without balance weights
- Designed to reduce harmonic vibration.
- Extended length, direct fit
Driveline angles and lifts
A rear driveshaft transfers power from the transmission and transfer case to the axle, and its joints must handle changing angles as the suspension moves. A lift raises the axle and increases those angles, which is why the joint design matters on lifted vehicles. CV joints run smoothly through angles, while U-joints can vibrate when angles get steep.
After installing a lift, check the angle at the transmission and axle ends while the vehicle is at ride height and under load. Look for vibration at speed, clunks when shifting, or grease leaking from the boot, since these can signal wear. Inspect the boot regularly and replace it if it tears, because dirt in a CV joint can shorten its life.
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | TER4612362 |
| Position | Rear |
| Length | Extended |
| Joint type | CV, Rzeppa with high-angle boot |
| Tubing | Laser-welded carbon steel, 2-3/8 inch |
| Balance | Zeroed out, no balance weights needed |
| Slip yoke eliminator | Not required |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2012–2018 Jeep Wrangler (JK) two-door models in the rear position.
Four-door Wrangler Unlimited models are not covered, and the JL and JT generations are not covered. Confirm fit for your year, model and trim before choosing this part.
Installation notes
The high-angle design matters most on JK models with a lift of 3 inches or more. Check joint angles after installing a lift, since this shaft is made to handle them.
What’s included
One rear driveshaft assembly with its CV joint and boot.









