Overview
The TeraFlex High-Angle Rzeppa CV Rear Drive Shaft, part TER4612302, is a rear driveshaft for the 2012–2018 Jeep Wrangler JK two-door. It uses a Rzeppa CV joint with a high-angle boot, which TeraFlex designed for the steep joint angles that come with larger lift heights.
Steep joint angles are the main problem a lift creates. A Rzeppa CV joint keeps torque transfer smooth while handling the high-angle misalignment that traditional U-joint shafts struggle with. The joint holds its strength at high angles, which is why this shaft is designed for JK models with a lift of 3 inches or more.
Key features
- Rzeppa CV joint with a high-angle boot for steep angles
- Laser-welded 2-3/8 inch carbon steel tubing
- Precision construction intended to reduce harmonic vibration at high RPM
- Zeroed out during final assembly for a centric fit without balance weights
- Extended length, direct fit, no slip yoke eliminator required
Driveline angles on lifted JKs
A lift tilts the axles and makes the driveshaft work at steeper angles, and that is where many stock shafts start to wear. A CV joint carries rotation smoothly through those angles, and the boot keeps grease in and dirt out. Driveshaft length and joint angle both change after a lift, so the setup should be measured again once the new suspension has settled.
Regular checks help catch problems early. Listen for clicking when turning, look for grease spray inside the wheel, and watch for vibration at highway speed. A torn boot is a common early sign, since dirt entering the joint shortens its life. Keep an eye on the transfer case output and pinion angle as well, because a driveline out of balance can cause the same symptoms.
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | TER4612302 |
| Position | Rear |
| Length | Extended |
| Joint type | CV, Rzeppa with high-angle boot |
| Tubing | Laser-welded 2-3/8 inch carbon steel |
| Balance | Zeroed out, no balance weights needed |
| Slip yoke eliminator | Not required |
| Fitment type | Direct fit |
Vehicle fitment
It fits the rear position on 2012–2018 Jeep Wrangler JK two-door models.
Confirm that your vehicle is a two-door Wrangler JK from 2012 through 2018 before choosing this part. The JL and JT models are not the same generation, so check the year, model and trim.
Installation notes
Check the lift height and the angle at each joint after installation, since this shaft is built for high joint angles. Lifts of 3 inches or more are where this design matters most.
What’s included
One rear driveshaft assembly with a high-angle Rzeppa CV joint and boot.









