Overview
The TeraFlex 4254100 is a U-bolt yoke conversion kit for the rear axle of the 2007–2018 Jeep Wrangler (JK). It is a direct fit for the JK in both 2-door and 4-door models.
The kit replaces the yoke and swaps the OEM Rzeppa CV flange for a standard CV cardan joint style yoke with a U-bolt style connector. The conversion is built to be stronger than the OEM setup and makes u-joint changes easier after a breakage.
Key features
- Replaces the OEM Rzeppa CV flange
- Standard CV cardan joint style yoke
- U-bolt style connector
- Includes the yoke, U-bolts and hardware
Driveline angles after conversion
Changing the rear connection at the axle alters the angles between the transmission, transfer case, driveshaft and pinion. Those angles decide how smoothly the joints rotate, so a conversion can bring on vibration if the driveline is not reset. A shop with a driveline angle gauge can measure the joints and confirm that the shaft length suits the new yoke.
Once the conversion is in, keep an eye on the joints during the first drives. Vibration at highway speed, a clunk when shifting or grease coming from the cap seals are all reasons to stop and inspect. Rear u-joints on a converted axle should be checked at every drivetrain service.
- Have the driveshaft length and joint angles checked after installation
- Inspect the U-bolts and yoke for play
- Re-check U-bolt torque after the first few drives
- Listen for vibration at highway speed
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | TER4254100 |
| Position | Rear axle |
| Yoke style | Standard CV cardan joint style with U-bolt connector |
| Includes | Yoke, U-bolts and hardware |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler (JK) in 2-door and 4-door versions with the rear axle conversion, and it is a direct fit for those years.
The kit is for the Wrangler JK. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Because the kit changes the drive shaft connection at the rear axle, the drive shaft will need to be checked for length and angle after the conversion. Plan the driveline work with a shop that has the tools to set the joint angles.
What’s included
The yoke, the U-bolts and the hardware for the U-bolt conversion.











