Overview
The TeraFlex HD Forged Adjustable Front Track Bar, part number TER1753420, is a front track bar for the Jeep Wrangler JL and Gladiator JT. It is recommended for 2.5 to 6 inch lifts and bolts into the factory locations with no cutting or welding. It is the same front track bar used in the 2.5 to 4.5 inch Alpine RT and Alpine CT suspension systems.
The front axle takes large side loads while turning, and those loads increase off road. The forged bar is built to withstand those side loads, which supports steering response and handling. A track bar also lets the front axle shift sideways for alignment and lets the suspension cycle through full travel.
The lift range for this bar is 2.5 to 6 inches. Choose a setup within that range, and check the fit for your vehicle before ordering.
Key features
- HD forged construction
- Adjustable front track bar
- Recommended for 2.5 to 6 inch lifts
- Bolts into factory locations, no cutting or welding
- Same bar used in the 2.5 to 4.5 inch Alpine RT and Alpine CT systems
- Part number TER1753420
Front track bars and steering
The front track bar works with the steering and suspension to keep the axle centered as the wheels move. Under hard turning and off-road loads, it carries a lot of side force, so the quality of the bar’s ends and bushings affects how the front end feels.
Front track bars are often replaced alongside other steering parts when a lift is added. Tie rod ends, drag link ends and the steering stabilizer can show wear sooner once the geometry changes, so inspect them while the bar is off or being adjusted.
Keep the bar’s ends clean and check for play after rough terrain. A bar that has moved off its set length will shift the axle, so recheck alignment whenever the bar has been adjusted or disturbed.
- Inspect tie rod ends and the drag link after a lift
- Check bar ends for play after rough trail use
- Recheck alignment after any adjustment
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | TER1753420 |
| Position | Front |
| Type | HD forged adjustable track bar |
| Recommended lift | 2.5 to 6 in. |
| Lift height field | 0 to 8 in. |
| Installation | Factory locations; no cutting or welding |
| Fit | Direct fit |
Vehicle fitment
The bar fits 2020 to 2021 Jeep Gladiator (JT) models, including Overland, Rubicon, Sport and Sport S trims. It also fits 2018 to 2021 Jeep Wrangler (JL) models, including Rubicon, Sport and Sport S two-door trims and Moab, Rubicon, Sahara, Sport and Sport S four-door trims.
Wrangler JK and TJ models, and Gladiator years outside 2020 to 2021, are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The bar bolts into the factory locations without cutting or welding. Set its length on the vehicle, then have the front alignment checked.
What’s included
The HD forged adjustable front track bar. Make sure the hardware you have matches what your installation needs.









