Overview
The Specialty Products 25460 is a front upper adjustable control arm for Toyota trucks and SUVs, and it fits the 1995–2004 Toyota Tacoma and the 1996–2002 Toyota 4Runner. It is sold as a pair. The arm is designed for vehicles that have run out of factory adjustment after a lift kit is installed.
The patented design adds up to 2 degrees of camber and a 0 to 4 degree caster change. These adjustments correct alignment angles while keeping factory ride quality.
The arm uses an OE style ball joint and new SpecRide bushings. Its hybrid tubular and forged steel design is built for racing and off-road use, and it installs as a remove and replace part.
Key features
- Patented adjustable design
- Up to 2 degrees of additional camber
- 0 to 4 degree caster change
- OE style ball joint
- New SpecRide bushings
- Hybrid tubular and forged steel construction
- Greaseable ball joints and xAxis sealed flex joints in bonded rubber sleeves
Adjustable arms and lifted trucks
On an older Tacoma or 4Runner with a lift, the factory upper arm may reach the end of its adjustment, leaving camber and caster out of range. An adjustable upper arm gives more room to restore those angles without changing ride height. The adjustment should be set on level ground with the truck at its final height.
Because this style of arm combines tubular and forged construction, the joint and bushing condition matters as much as the arm itself. Inspect the factory lower arms and ball joints before installation, since worn parts can prevent a stable alignment. Off-road use places more load on the joints than street driving does, so check them after rough trips.
- Set camber and caster after the lift is complete
- Check lower ball joints and bushings before installing
- Inspect steering components for play
- Recheck alignment after the first few trips
Specifications
| Brand | Specialty Products |
|---|---|
| Part number | S/P25460 |
| Position | Front upper |
| Type | Tube |
| Construction | Hybrid tubular and forged steel |
| Camber change | Up to 2 degrees of additional camber |
| Caster change | 0 to 4 degrees |
| Ball joint | OE style, greaseable |
| Bushings | New SpecRide |
| Quantity | Pair |
Vehicle fitment
It fits the 1995–2004 Toyota Tacoma and the 1996–2002 Toyota 4Runner, across the base, limited, SR5 and other trim levels of those trucks.
Confirm fit for your vehicle’s year, model and trim before ordering, including for later-model Tacoma and 4Runner trucks and the Tundra.
Installation notes
This is a remove and replace arm, so the factory upper arm comes off and this arm bolts in its place. Because it changes camber and caster, have the alignment set after installation.
What’s included
A pair of front upper adjustable control arms with OE style ball joints and new SpecRide bushings.







