Overview
The Fabtech FTS24128 is a short arm lower link set with 5 ton joints for the 2007–2018 Jeep Wrangler JK. The set covers the front and rear lower links, and it is a direct fit for the trims covered.
The company has more than 20 years of experience in aftermarket suspension design, and it develops its products with in-house engineers, software and fabrication equipment. Confirm link lengths and the intended lift before ordering.
Key features
- Short arm design for the front and rear lower links
- 5 ton joints included
- Direct fit to the listed JK trims
- Front and rear set in one kit
- Part number FABFTS24128
Lower links and axle location
Lower links hold the axle fore and aft and carry the forces from acceleration and braking. Replacing them changes the way the axle moves through its travel, which is why alignment and caster are affected. Short arm designs are often chosen to improve articulation and reduce bind, but the change must be checked against the rest of the suspension.
Joints at each end of the links wear over time, so inspect them for play and boot damage when the links are installed. Driveline angles should be checked after the install because the axle position changes. Link sets are often paired with a track bar or steering components, and those parts may need inspection during the same job.
- Check joint play and boots
- Confirm caster and driveline angles
- Inspect track bar and steering parts
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FABFTS24128 |
| Type | Short arm lower link set |
| Joints | 5 ton |
| Position | Front and rear |
| Fitment | Direct fit |
Vehicle fitment
Covered trims for the 2007–2018 Jeep Wrangler JK are 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X, in both 2-door and 4-door bodies.
Wrangler JL and Gladiator models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The link set changes axle geometry because lower links carry the fore and aft location. Check alignment, caster and driveline angles after the install.









