Overview
The Rubicon Express Slip Yoke Eliminator Kit, part number RE1801, is for NP231 and NP242 transfer cases. It converts the slip yoke output at the rear of the transfer case to a fixed flange yoke, which Rubicon Express recommends for off-road use and for lifted vehicles.
A stock Jeep slip yoke output is not suited to off-road use or to the steeper driveline angles that come with a suspension lift. A fixed yoke paired with a CV drive shaft is the arrangement suited to lifts over 3.5 inches, and the conversion is needed on lifts over 3.5 inches.
The kit requires modifying the factory output shaft. Drill and tap holes are included for the installation, and the drive flange is machined from solid stainless steel for strength and corrosion resistance.
Key features
- Fixed yoke conversion for NP231 and NP242 transfer cases
- Drive flange machined from solid stainless steel
- Drill and tap included
- Flange style yoke
- Recommended for lifts over 3.5 inches
Driveline angles after a lift
Lifting a Jeep changes the angle between the transfer case output and the rear driveline. A slip yoke that works at stock height can bind or vibrate once that angle grows. A fixed flange yoke keeps the shaft at a set length, so the driveline angle is managed by the drive shaft and joints instead.
Before installing, check your lift height and measure the existing shaft length. Look for vibration at highway speed, a clicking or binding feeling on turns, and wear on the u-joints, since those signs point to angles that need attention. Re-check the rear driveline angle after the first few drives and after any suspension change.
- Confirm lift height before ordering driveline parts
- Re-check driveline angle after the first drives
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1801 |
| UPC | 614901438949 |
| Transfer case models | NP231 and NP242 |
| Yoke type | Flange style |
| Drive flange material | Stainless steel |
| Output shaft | Modify the factory output shaft |
| Extension housing | Not included |
| Drill and tap | Included |
| Recommended lift | Over 3.5 inches |
Vehicle fitment
The kit is built for NP231 and NP242 transfer cases. Confirm your transfer case model and your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit requires modifying your stock output shaft, and the included drill and tap are used for the mounting holes. Rubicon Express recommends pairing the conversion with a CV drive shaft, style RE1898. Check the rear driveline angle after installation.
What’s included
The flange style yoke, the stainless steel drive flange, and the drill and tap.
Not included: A CV drive shaft (Rubicon Express recommends style RE1898) and an extension housing.






