Overview
The Rubicon Express RE1883-365 is a black front CV drive shaft with a 1310 series yoke and a 36.5-inch shaft length. It is compatible with Atlas transfer cases and any other 1310 series CV yoke, and it fits 2- and 4-door models.
This shaft does not require a slip yoke eliminator. It is an extended-length shaft rather than a stock-length one, so measuring the driveline matters more than it would for a stock replacement.
Key features
- Front CV-type driveshaft
- Built for Atlas transfer cases and any 1310 series CV yoke
- 36.5-inch shaft length in black
- Extended length, not stock length
- No slip yoke eliminator required
- Fits 2- and 4-door models
Driveline angles and vibration
A front CV driveshaft transfers power through the front axle, and its angles change as the suspension moves. An extended shaft can change those angles, which can show up as vibration at speed or as wear on the CV joints. Checking the driveline angles after installation helps keep the joints working within their range.
Inspect the boots and joints regularly for grease loss, tears and play. Keep the slip stub clean and lubricated where it applies, and recheck the yoke bolts after the first few drives. If a vibration appears after a lift or a tire change, the driveline is one of the first places to check.
- Check CV boots for tears and grease loss
- Look for vibration that changes with speed
- Recheck yoke bolts after the first drives
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1883-365 |
| UPC | 614901439410 |
| Shaft type | CV, front |
| Yoke | 1310 series |
| Shaft length | 36.5 inches |
| Length type | Extended |
| Slip yoke eliminator | Not required |
| Finish | Black |
| Models | 2- and 4-door |
| Required part | RE1810 (not included) |
Vehicle fitment
Fit depends on the transfer case, yoke and length. It works with Atlas transfer cases and any 1310 series CV yoke at 36.5 inches, and a driveshaft has to match all three.
Confirm your vehicle’s year, model and trim before ordering. A yoke that is not 1310 series will not match this shaft.
Installation notes
Measure before ordering. Length is taken center to center on the u-joint with the slip stub at the center of its travel, with the vehicle on the ground in its running position. The shaft requires RE1810.
What’s included
The front CV driveshaft, 36.5 inches long with a 1310 series yoke.
Not included: RE1810, which the shaft requires.

