Overview
The Rubicon Express CVF rear drive shaft, part number RE1887-240, is a CV style rear shaft with a 1310 series yoke. It is for 2-door models with a manual transmission only, and it does not require a slip yoke eliminator.
Driveshaft length depends on the vehicle, so measure the driveline before installing the shaft, following the steps below.
Key features
- CV style rear shaft in the extended length
- 1310 series yoke
- No slip yoke eliminator required
- Rear position, for 2-door manual transmission models
- Adapter RE1805 is needed on some transfer cases
Driveline angles and shaft length
A rear drive shaft has to match the angles of the transfer case and the axle. Changing ride height or pinion angle changes those angles, which is why shaft length and joint angles should be checked together after any lift or spring change. A shaft that is too long can bottom out the slip stub, and one that is too short can pull apart.
CV style shafts run at angles differently than a conventional U-joint shaft, but they still need a clean, correct installation. Keep the boots intact, keep dirt out of the joint, and confirm the yoke fits the transfer case before ordering. Vibration at speed, a clunk when shifting into gear or grease leaking from the joint are all reasons to inspect the shaft.
- Check angles after any lift
- Inspect CV boots for splits
- Confirm the yoke matches the transfer case
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1887-240 |
| UPC | 614901439427 |
| Position | Rear |
| Joint type | CV |
| Length type | Extended |
| Yoke | 1310 series |
| Slip yoke eliminator | Not required |
| Transmission | Manual only |
| Body style | 2-door models |
| Transfer case adapter | RE1805 (some models with an 8-bolt round yoke) |
| Fitment | Universal fit by position |
Vehicle fitment
This shaft is for 2-door manual transmission vehicles and fits by position, so its length must be matched to your vehicle.
Confirm the transfer case yoke and your vehicle’s year, model and trim before ordering.
Installation notes
Measure center to center on the U-joint with the slip stub at the center of its travel, with the vehicle on the ground in its running position, to get the correct length.
What’s included
One CV rear drive shaft with a 1310 series yoke.
Not included: the RE1805 adapter, which some transfer cases need.

