Overview
The Rubicon Express RE1898-335 is an extended rear CVF drive shaft for use with the RE1807 and RE1801 slip yoke eliminator kits and with Currie Enterprises tail shaft conversion kits.
The shaft is universal fit, so measure your driveline before choosing a length. Measure from the flange face to the center of the rear U-joint, with the slip stub at the center of its travel and the vehicle in the running position on the ground.
Key features
- Rear CVF drive shaft
- Extended length
- RE1807 and RE1801 slip yoke eliminator compatibility
- Currie Enterprises tail shaft conversion compatibility
- Slip yoke eliminator required
Cold-weather and wet-trail care
Drivelines take water, mud and road salt, and CV joints are more sensitive to contamination than the spider joints on some shafts. Keep the boot intact and rinse the shaft after trips through deep water or salted roads. Dried-on grit is hard to remove once it works into the joint.
Winter use adds a different concern. Cold grease stiffens, which can make the joint feel rough on the first drive of the morning. Let the vehicle warm up gently before loading the driveline, and listen for clicks or knocks during the first few turns.
Track the shaft’s condition in a simple log so changes show up early.
- Rinse after deep water crossings
- Check boot seals after salt exposure
- Warm up before hard driving in cold weather
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1898-335 |
| UPC | 614901439656 |
| Joint type | CV |
| Length | Extended |
| Position | Rear |
| Fitment | Universal fit |
| Slip yoke eliminator | Required |
| Measured from | Flange face to center of rear U-joint |
Vehicle fitment
No vehicle is named for this universal fit shaft. Choose the eliminator or conversion kit first, then confirm the length.
Confirm your vehicle’s year, model and trim before ordering, and verify the transfer case and eliminator match.



