Overview
The Rubicon Express RE1860-185 is an extended rear CVO drive shaft. It is a universal fit shaft, so it is not tied to one vehicle, and it works with Atlas transfer cases and other 1310-series CV yokes.
Because the shaft is sized to a driveline rather than a model, the correct length depends on your vehicle. Rubicon Express gives the measurement method as center to center on the U-joint, with the slip stub at the center of its travel, taken with the vehicle on the ground in the running position.
Key features
- CV joint design
- Extended length
- Rear position
- Requires a slip yoke eliminator
- Works with Atlas transfer cases and 1310-series CV yokes
Driveline angle and balance
A rear CV drive shaft carries torque from the transfer case to the axle while the suspension moves through its travel. Changes in driveline angle, especially after a lift or an axle change, affect how smoothly the joints run and how much vibration reaches the cabin. Because the length is set by the driveline, a shaft that is too long or too short can bind the slip stub or bottom out the joints.
Joints and yokes should be checked after installation. Look for play at the U-joint caps, grease leaks at the boot, and wear marks on the slip stub. Re-torque the yoke fasteners after the first few drives and recheck the eliminator bolts, since they loosen as the driveline settles.
- Check U-joint caps for play after the first drives
- Inspect CV boots for cracks or grease loss
- Look for scoring on the slip stub or yoke
- Recheck eliminator and yoke fasteners periodically
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1860-185 |
| UPC | 614901439083 |
| Joint type | CV |
| Length | Extended |
| Position | Rear |
| Fitment | Universal fit |
| Slip yoke eliminator | Required |
| Yoke | 1310 series CV |
Vehicle fitment
It is not tied to one vehicle. Choose the length from your own driveline measurement rather than from a model name.
Confirm your vehicle’s year, model and trim before ordering, and check the driveline length against the measurement method above.
Installation notes
The slip yoke eliminator is required with this shaft, so order the eliminator kit for your transfer case together with it.

