Overview
The Rubicon Express RE1898-375 is a rear CVF drive shaft in extended length. It is compatible with the RE1807 and RE1801 slip yoke eliminator kits and with Currie Enterprises tail shaft conversion kits.
The shaft is universal fit and does not target one vehicle. Choose the final length from a measurement taken from the flange face to the center of the rear U-joint, with the vehicle on the ground in the running position.
Key features
- CV rear drive shaft
- Extended length
- Compatible with RE1807 and RE1801 slip yoke eliminator kits
- Compatible with Currie Enterprises tail shaft conversion kits
- Slip yoke eliminator required
Before you install
A CVF rear shaft replaces the stock driveshaft and has to be set to a precise length. The shaft moves in and out as the rear suspension cycles, so the slip stub should sit near the middle of its travel when the vehicle is on the ground. Getting that position right protects the joints and the transmission output seal.
Many builds that use this shaft also change the rear axle, springs or transfer case mounts. Each of those changes shifts the driveline angle, so the shaft length is best confirmed after the rest of the build is complete. Mark the measurement points clearly before making any cut, and keep the factory length on hand for reference.
- Measure with the tires at ride height, not on jack stands
- Use a level surface for the measurement
- Check the slip stub for smooth movement before final assembly
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1898-375 |
| UPC | 614901439700 |
| Joint type | CV |
| Length | Extended |
| Position | Rear |
| Fitment | Universal fit |
| Slip yoke eliminator | Required |
| Measured from | Flange face to center of rear U-joint |
Vehicle fitment
No vehicle is named because the shaft is universal fit. The eliminator kit and driveline length decide whether it suits a build.
Confirm your vehicle’s year, model and trim before ordering, and check the kit compatibility against your build.

